I was waiting for this indeed!!!!

Nice comprehensive review! Two things, hanger width does not affect pumping capability if you use a correct bushing duro for your weight. Also, you should check the method of measurement with your durometer, I'm pretty sure that 98a duro in front isn't this turny.

You missed a very important fail in this truck setup. The kingpin will get loser and loser while you carve. Actually I have to tighten them up to three times a day. This is because the carving motion turns the kingpin out. Looks like a serious construction issue. Right now Iam looking for an axial bearing which I can place between the kingpin and the washer on the top. Hopefully this will fix it. Any better ideas?

@SurfskateLove

9 ай бұрын

That's good to know. And I wish I had another idea for you. I'd contact YOW and see what they say.

@MegaCartoonclassics

9 ай бұрын

@@SurfskateLove thanks a Million

@MegaCartoonclassics

9 ай бұрын

@@SurfskateLove I installed an axial bearing under the kingpin top, but it doesn't help with this issue. Tbh iam very disappointed of yow to offer such product. So I could use locktide but than I never can change the stiffness. It's a pitty.

@1234eyes1234

8 ай бұрын

@@SurfskateLove Did they answer, is there a solution for it?

Do you find that the pivot cups are too short? Indy and YOW pivot cups from riptide are just a millimeter or two lower than the lip of the pivot cup socket in my experience

@SurfskateLove

Жыл бұрын

I don't believe so.