A "How-To" for designing successful windings with the X-Winder 4-Axis filament winder
Жүктеу.....
Пікірлер: 10
@BluesDoctor9 жыл бұрын
Turner, outstanding quality presentation. Looking forward to upgrading mine to 4 axis.
@NSAwatchesME7 жыл бұрын
very good :)
@mahrezaitm.51622 жыл бұрын
Amazing illustration of filament winding. How did you get the mandrel out of the pressure vessel? Have you considered a thin liner in your tank design? Thanks very much.
@MrJhuber6 жыл бұрын
Can I use for building elbows?
@Addmaster1Ай бұрын
Where can I buy the software? Are their already winding pattern preinstalled
@taylorinase80944 жыл бұрын
How did you pin the filament lead to the mandrel prior winding?
@GavynPendleton5 жыл бұрын
how do how separate the winding from the mandrel with a 4 axis print
@coleajluni92062 жыл бұрын
I'm dealing with bunched up ends on my winds, is there anyway to fix this
@ezesirito8 жыл бұрын
Hello Turner, I've been trying to contact you regarding the Xwinder but I can't access to Xwinder web page
@treelimb486 Жыл бұрын
Amazing how collectively bad these instructions are.
Пікірлер: 10
Turner, outstanding quality presentation. Looking forward to upgrading mine to 4 axis.
very good :)
Amazing illustration of filament winding. How did you get the mandrel out of the pressure vessel? Have you considered a thin liner in your tank design? Thanks very much.
Can I use for building elbows?
Where can I buy the software? Are their already winding pattern preinstalled
How did you pin the filament lead to the mandrel prior winding?
how do how separate the winding from the mandrel with a 4 axis print
I'm dealing with bunched up ends on my winds, is there anyway to fix this
Hello Turner, I've been trying to contact you regarding the Xwinder but I can't access to Xwinder web page
Amazing how collectively bad these instructions are.