Thank You Sir, using a Vsett 8 and your video is pretty helpfull. Kudos

Nice sir

So I got this Error code 008 which they said only could be an error with the throttle/display. After checking the magnet and still no success i ordered a new throttle and display with 3 new keys. After replacing the throttle, and i turned on the scooter again, I still get the same error code 008. So it cannot be the throttle after all. Do you have any idea where the error is. I dont know where to start troubleshoot. Thank you.

the first thing you did was test the charger and it was fine…. Then last thing it was only outputting 52v

@UrbanMachina

Жыл бұрын

Yes, they were 2 different chargers to show what a faulty charger would output.

@wisdomspitter7688

Жыл бұрын

@@UrbanMachina I had to do a double take myself to notice the second charger. If someone were charging with dual chargers and one was bad would that create issues or would the good charger overcome the lower output unit? Or would you get a partially charged battery? I'm assuming the BMS recognizes the presence of two chargers and divides accordingly. With that in mind you'd have to unplug the shitty charger for the good one to handle the whole battery right? Also what's the 3rd pin about? Thanks for the vid.

Maybe someone can help me with my issue. Vsett 10+ does not turn on after charging overnight. It had about half of the battery charged last I had used it. What might the issue be?

The VSETT 11+ got it right with its charging ports.

What do I do if my battery is reading 86v?

@dmastermanga

Жыл бұрын

Check to see if your multimetre is callibrated to the correct setting first. If it is 86v, your battery could possibly already have dead cell(s). Try to keep testing your battery and changing the metre's dial to the correct voltage setting.

😩 P r o m o s m