Volvo Gearbox Going Into Limpmode? Watch This First

Автокөліктер мен көлік құралдары

This video explains that an injector wiring fault can throw your autobox into limp mode.
Many people mistake the gearbox limp mode to be the cause of a severe mechanical fault with the box, which can result in very expensive repair.
On my D5 engine, the injector misfire triggers the "anti-skid service" (which is very common by other means) and most importantly, the "transmission service required" which throws the box into limp mode, restricting you to only one gear, apart from "Park" and "Reverse"
Rectifying the misfire usually in most cases solves the limp mode.

Пікірлер: 10

  • @defeyago
    @defeyago Жыл бұрын

    Thanks a lot man!! I had my XC90 thrown in the back of my house during 6 month not knowing how to solve this. I cleaned the connectors/plugs and changed 2 of them and all problems went away. Antiskid and gearbox problems. Incredible. Thanks again, solved with just a couple of dollars.

  • @noreazons2821
    @noreazons28212 жыл бұрын

    Not much mention of this online but this solved my car randomly cutting out, thanks alot!! 👍

  • @martyjackson4806
    @martyjackson48062 ай бұрын

    Thanks. I had a bad coil on my 2.5T and the trans went into limp mode. Got a used coil and it's working great now.

  • @koolkid1471
    @koolkid14712 жыл бұрын

    Nice video man, very helpful

  • @peterduncan123
    @peterduncan1232 жыл бұрын

    Nice video, hopefully this helps

  • @xortolaa
    @xortolaa Жыл бұрын

    Hello, was your failure happening from engine/gearbox cold or after some minutes driving? I have the same problem, but is happening after some minutes driving (seems my problem is related to gearbox/ATF pressure). Thanks in advance

  • @nabeeljacksonrhoda6480

    @nabeeljacksonrhoda6480

    Жыл бұрын

    I just had this issue rock up yesterday and stopped the car. It started flaring very ridiculously in 4th and 5th. Instead just kicking it no gear, it flares over 3ooorpm and upto 4ooorpm. So after stopping the engine, waiting a bit, I drove off and the flaring was minimal. Still there but not as bad. I need to run a diagnostic to check the codes because this video somehow hints at the issue that I may or not have since I replaced my loom as the older loom had some knacks in it. This one has a few but much lesser breaks in the loom or at the connectors. Car starts first time and very strongly too. To add, I had a mild flaring issue when the engine is hot. Nothing when it's cold.

  • @nabeeljacksonrhoda6480

    @nabeeljacksonrhoda6480

    Жыл бұрын

    I've done the atf flush which improved the changes dramatically but it tends to return after a time do now I'm thinking the valve body needs a clean up

  • @Evergen8

    @Evergen8

    10 ай бұрын

    @@nabeeljacksonrhoda6480what ended up being the issue? Did you fix it?

  • @stelladreamz6841
    @stelladreamz68412 жыл бұрын

    My nan has no teeth in her mouth.

Келесі