Vauxhall Astra H - Front Brakes Replace
Автокөліктер мен көлік құралдары
In this video we show you how to replace front discs and pads on a 2008 vauxhall astra 1.9cdti.
The following tools/materials are required:-
- 17mm wheel nut socket
- 7mm allen socket
- 18mm socket
- Ratchet
- Torx 35 bit
- Hammer
- Flat head Screwdriver/small pry bar
- Caliper wind-back tool
- Torque wrench ranging from 25Nm to 110Nm
- Wire brush
- Brake grease
- Brake cleaner
- DOT 4 brake fluid
- Brake pads
- Brake discs
Link to Brake bleeding video:-
• How To Bleed Your Brakes
DISCLAIMER
All work should be carried out by a competent professional and torque settings should be obtained from your own source.
Don't Forget to visit our website and online store!
www.dtb-performance.com
Пікірлер: 18
Need you in my life right now 😂 need to do all 4 disc n pads on mine.
@DropTheBoxOfficial
4 ай бұрын
It's not a bad job to do 💪
Very professional work!
@DropTheBoxOfficial
3 ай бұрын
Thanks for the feedback 👍
Many thanks. It helped me a lot.
@DropTheBoxOfficial
2 ай бұрын
No problem thanks for the feedback 👍
Brilliant video mate, appreciate the editing. Very helpful 🙌👌🏴
@DropTheBoxOfficial
Жыл бұрын
Appreciate the feedback ☺️
@nooby123noob3
7 ай бұрын
Hi mate did you pump the breaks after you put the break reservoir cap on?
@nooby123noob3
7 ай бұрын
Should you not pump them before you put the cap back on? Im not trying to be rude its because I wont to know for myself , thanks
@_3.time_
7 ай бұрын
@@nooby123noob3 well the cap holds pressure mate, so I wouldn’t unless you want brake fluid pissing all over the shop 🤣
On mine astra h im bleeding the brakes done three of them but come cross front caplier right nipple wont move so ordered new front capliers, will i have to bleed all four again or can l just bleed the new caplier??
@DropTheBoxOfficial
Ай бұрын
Clamp the caliper brake pipe before fitting the new one, then you'll only need to bleed that caliper 👍
Replaced discs and pads on left front, cleaned slide points and put on copper grease also silicone greased slide pins. But brakes are still binding. Any idea?
@DropTheBoxOfficial
2 ай бұрын
Make sure all your brake lines are in good condition (none have been crushed) Possibly an issue with your caliper.
Prowadnic zacisków systemu ate się nie smaruję
@DropTheBoxOfficial
Ай бұрын
It's always recommended to lubricate the sliders with fresh grease
@krzysztofk3335
Ай бұрын
Prowadnice po których przesuwa się klocek hamulcowy to tak ale prowadnice po których przesuwa się zacisk ,prowadnice w gumowych osłonach się nie smaruję