Use Moldex3D warp results to correct the injection mold upfront, for high succes that the molded plastic part falls within specifications on the first trial. After running the Moldex3D simulation, you can export the reverse deformed model representing shrinkage and warp. It's not ideal to apply the entire model directly due to potential challenges with parting surfaces and ejection directions, etc., but the model can be used to compensate for specific areas. All of this, of course, depends on the accurate calculation of shrinkage and deformation, which requires good input parameters in the simulation such as material data, process parameters, inlet geometry, cooling layout, etc. With Moldex3D and support from FlowHow, you can streamline your development of injection molded parts and ensure high quality from the start.