Thank you for the Introduction to this product! I made a purchase the first day I saw your video. At first I thought how could I make such a frivoulous purchase??? But after using it, I realized how much pressure it took off my hands, AND I do not have bead waste, they seem to stay in the spinner bowl better than the wooden one. And of course, it is much faster than the manual spinner. Thanks again!!

@BeadBlossom

Жыл бұрын

You are so welcome, Sherry! I'm so happy to hear that this spinner was such a great investment for you. Happy beading!

The noise doesn't seem as bad at slower speed. Since I can't use the higher speed anyway, it would work fine for me. Thanks for the review

@BeadBlossom

Жыл бұрын

That's true! Lower noise at lower speeds.

Where can I get a good needle from

Does the lid with the slot in fit on while it is spinning? Was just thinking if your wire hook fits through it should help stop the beads flying out on the high setting. Just a thought to try.

@BeadBlossom

Жыл бұрын

The lid does snap on tight, but I think putting the wire hook through the hole would make it harder to get the wire in and out without beads coming back off. I think it would help dump beads if you keep it tipped up and don't move it around while pouring.

Did you make those flowers, at the end of the video. Do you have a video on how to make them?

@BeadBlossom

Жыл бұрын

Hi Samantha, Yes I did make those flowers. I don't have a video, but I do have a PDF pattern for my design available on my website - beadandblossom.com/product/french-beaded-african-violets-pdf-pattern/

@samanthanicholson9015

Жыл бұрын

@@BeadBlossom thank you I'll take a look!

somebody Knows if the Hobbyworker and the Darice bowls are compatible between the two spinners?

@BeadBlossom

Жыл бұрын

They are somewhat compatible. They aren't the exact same shape, so it's not a perfect fit on the spindle, but I was able to get the darice bowls to work on the Hobbyworker.