Twin 70mm EDF Plane - 3D Prints & Foam-board
Ғылым және технология
#BlameAndre #FliteTest #Foamboard
It's been a long winter, I've been flying but missed my EDF's.
So I scratch built this plane. "The Platypus"
It's like someone strapped some jet engines on a WWII bomber and added floats for good measure.
60" wingspan, 45" long
70mm 6 blade edf, 80amp esc and a 4S 6000 pack.
I'm going to see if I can slim down the fuse and add some efficiency to up the flight time.
Thanks for watching.
Follow Me On Social Media
KZread - / @blameandre
Instagram - / blameandre_rc
Пікірлер: 10
Awesome! Looks like a fun cruiser!
You my friend have good talent , because there aren't many RC scratch builders here on YT, THANKS for the video
Жыл бұрын
Thanks 👍
Awesome. All of the trust on that one!!
You had me at twin 70mm.... Platypus Yes! Lots of down elevator. Uh oh that sounds like one of my designs tragically tail heavy 😜
Жыл бұрын
It trimmed out fine but I’ll do a little work to add more flight time for sure. 4 minutes is bit enough.
I like the nacelles. Did you design them they look good.
Жыл бұрын
No, that is definitely outside of my skill set, www.thingiverse.com/thing:3365738
What is your next build?😁😁😁👍
Жыл бұрын
Not sure yet, I did a huge 4 motor bomber a few years ago but might try and do an OV-10.