This video saved me 500 pounds what an absolute hero

Very helpful. Potentially saved us a fortune. Part on its way.

@How-to-repair

2 жыл бұрын

. Thanks 👍 for watching and please remember to subscribe to the Channel as that's what keeps us going in able to make the video for you

We have had a white night dryer sat unused in the garage for a few years. Recently we have had cause to use it and thanks to your vids I have cleaned it out, replaced the hose. Then the motor capacitor failed so I fixed that. Now it looks like heating element is done. Great videos helping me keep an appliance going that I think 95% of people would have sent to the tip

Replaced the heater element in a Baumatic BTD1 which is identical to the White Knight machine in your video. Thanks for the detailed explanation, without which, I would probably have scrapped the machine. Working fine again!

Great video thanks.. replaced the heating element and it's working perfectly again. Not as easy as it looks, but the most difficult part is lining up the drum properly when reassembling, the felt at the front doesn't hold it in place and it keeps dropping out. Managed it in the end though & saved me a fortune... thanks.

Great video made fixing my dryer an easy job thank you

Good vid and really helped me strip down my dryer, clean and check elements and all thermostats. No obvious probs so hope the service does the trick

Hi These are great videos. My igniter starts to click and the flame comes on for a few seconds and then goes out. Can you help ?

Very helpful, thanks.

@How-to-repair

4 жыл бұрын

Can you do us a favour and please share this video on your timeline Facebook twitter etc . This will help other people who can’t get engineers out to help them. kzread.info/dash/bejne/pHqtqaOBhqm7h5s.html&t facebook.com/how.to.repair.appliances/ Stay safe

My White Knight heating element was faulty and I replaced it as per your instruction. It sounds fine but I get a strong electrical smell coming from the machine when I switch it on. Is this normal for a new element or is there a wireing problem? I dont see any smoke.

Ive tested the thermal element & cut off valve, both are providing a continuity signal via the multimeter however it still blows cold air

@How-to-repair

2 жыл бұрын

have you checked foward thermostat. Thanks 👍 for watching and please remember to subscribe to the Channel as that's what keeps us going in able to make the video for you

Much appreicated.

@How-to-repair

4 жыл бұрын

Iam Glad we could help you. If you ever need help please use our site for 24 hour response www.how-to-repair.com/help/contact-us/ If have a question please use our site for 24 hour response www.how-to-repair.com/help/contact-us/ Please remember to subscribe to our channel kzread.info Remember to Shop with www.how-to-repair.com and it would help us by posting the video or website on your timeline. This helps us a lot and if we really helped you can always buy us a beer how-to-repair.com/help/buy-paul-a-beer/ Please remember to mark us to your favourites also I would be grateful if you would subscribe to our channels social media as this really helps my site and keeps us going. KZread. kzread.info Facebook. facebook.com/how.to.repair.appliances