Thanks for that great information. I am considering doing the floor only on my 1998 Ranger and your installation video may have swayed me away from another product. Very informative thanks. 👍

@ScruffyCityFishing

2 жыл бұрын

Very welcome! I hope it works out for you. So far I really like it in my boat.

I am number 907 subscriber. Thanks for your expertise😊

Spray with a drywall hopper for professional results

Im going to do this on my center console. I think towards the end of the last coat im going to splash some black paint all over it to break up the look. I saw one while it fishing recently looked really good.

@ScruffyCityFishing

Жыл бұрын

That sounds like a great idea! I bet it will look really good and the broken pattern may help hide dirt.

I think you were supposed to leave the primer sit for 30 min after mixing the 2 parts for it to do it’s chemical bonding.

@ScruffyCityFishing

10 ай бұрын

Really? I may have missed that step. Makes sense though. Thanks for watching and catching that.

looks great!!!!! how was it pulling the blue tape off?? i see some still on the side?? would you have pulled it off sooner??? im looking to do the floor of my bayliner!!! thanks 🤙🤙🤙

@ScruffyCityFishing

Жыл бұрын

Thanks! I think if I pulled it off sooner, maybe the glue wouldn’t have stayed on my Fiberglass as well. But also would have to re mask between coats.

@mauritobias8759

Жыл бұрын

@@ScruffyCityFishing yeah i hear ya on that!!! good stuff🤙🤙

I’m currently working on our boat floor and notice the pinkish colored thick coating that you were sanding over. What is that? Some of ours came off attached to the old carpet and I’m not sure what to replace it with.

@ScruffyCityFishing

Жыл бұрын

I think it’s fiberglass resin. Far from an expert though. Good luck on the floor! Are you going with carpet?

Does it stay cooler on the bare feet when it’s 80 degrees out?

@ScruffyCityFishing

Жыл бұрын

Thanks for watching. Sorry, overlooked some comments recently. It stays cooler than the carpet in my opinion.

Need to remove the tape while it is still wet.

@ScruffyCityFishing

2 жыл бұрын

Thanks for watching. That crossed my mind but I was worried about over brush with the 2nd and 3rd coats.

Wire brush on a drill

How is coating holding up?

@ScruffyCityFishing

2 жыл бұрын

So far, really well. It does get dirty easier than I anticipated. I guess really it’s just hard to scrub as it’s very grippy.

How has this held up for you?

@ScruffyCityFishing

Жыл бұрын

I made a follow up 1 year video if you want to see all the details, but it’s held it’s pretty well over all. It’s harder to clean than I anticipated, but really tough stuff.