Mate, you just keep going and going👍. Massive respect.

@Mickhanic-garage

6 күн бұрын

@@armannvanhelden4884 Thankyou... Its crackers really.. I got in from work last night and finished the welding g and paintwork on the Skoda too

Hell of a job mate, gonna look forward to following this restoration 👍🏻👍🏻

@Mickhanic-garage

8 күн бұрын

@@dazwatson86 it's a bit of a job but all small.. just anything I need has to come from Germany..

Looks like stripped chopped triumph herald. Don't envy the work ahead. All the best fella.

@Mickhanic-garage

7 күн бұрын

@@MrMaxidc Cheers, lots to do but once the shell is solid again then I can start going over the mechanicals and male some progress. It's not a quick job but won't be a concours restoration but a good ressurection and paint.

Great video again Mick. I think a new welder is required. Good luck.

@Mickhanic-garage

7 күн бұрын

@@redsworkshopuk Cheers, I reckon you're right... the welder is old and can't do a lot without cutting out..

Lots of little repairs, not bad for such an old car. The wax worked well where it was on the panels! In comparison to BL cars of the time which needed wending on their first MOT, it's pretty good!

@Mickhanic-garage

8 күн бұрын

@@gord307 absolutely they were never meant to last long, this is 46 years old now... Be easy to sort once stripped and on its side

I recommend that you remove the roof panel. Bend the edge and peel off the panel. Judging by the condition of the car from below under the panels, it is rotten on top as well. It’s good that you have a sedan and not a station wagon, otherwise there would be even more body problems.

@Mickhanic-garage

8 күн бұрын

@@daniilvolynskiy2554 Hi yes I was planning to remove the roof but then saw how it's connected. I had a look inside the top channel and down the fro t and rear pillars with an inspection camera, slight surface rust in ther but nothing crispy at all.. Dry and dusty in there. Where I can get my fingers in the gap and press down on the top if the frame it's all solid..

stick a reliant 850cc engine and gearbox in her to keep up with modern traffic it would be perfect that car. good acceleration 80 / 90 mph very fuel efficient easy to work on almost bullet proof. makes good sence

@Mickhanic-garage

7 күн бұрын

Would be a bit awkward these are front wheel drive.. Being an older one I'm keeping this standard.. I have modified a couple of my old eastern bloc cars

@chrislewis4830

7 күн бұрын

@@Mickhanic-garage it cant be that hard make a tunnel and use a rear axle off a reliant thats how most trikes are made i mean a bit of extra fabrication would be needed like Mounting points( engine gearbox suspension ) and extra braces to allow for a drive shaft to travel through the chassis frame. But yeah it would be extra work