TPA3255 amplifier board before and after remove thermal pad
Жүктеу.....
Пікірлер: 17
@dennissinger7880 Жыл бұрын
Nvarcher tpa3255 have nice board , same Quality sure electronics:) but more expensive
@huseyincerez34506 ай бұрын
Bu devrelerin en iyisi hangisi ses olarak.
@luanvo4207 Жыл бұрын
Bạn cho hỏi chạy được 48v ko ạ, với tại mình có loa kéo chạy 3251, mình thay thành 3255 nâng boots nguồn lên 48v khi hát nhạc ko sao nhưng ca mic lớn bị rè loa kiểu mất sóng micro ấy
@dirceub.r5907
Жыл бұрын
Jovem, Texas Instruments diz que pode-se usar até de 18 até 48v, mas nos anúncios do Aliexpress, diz que uma tensão segura, seria de até 36v.
@peshcom84 Жыл бұрын
the project turned out, only the cooling radiator was finalized, the thermal paste was replaced kzread.info/dash/bejne/Yppts9R-nMyskdo.html
@peshcom84 Жыл бұрын
hello, how good is this amplifier board?, I am also going to experiment with it, try d class
@trungqn1890
Жыл бұрын
Hi, this board is cheap, low finish quality but sound quality is quiet good
@peshcom84
Жыл бұрын
@@trungqn1890 thanks, I already understood that there can be unpleasant surprises with this board, for example, with cooling, apparently you need to immediately change the thermal paste
@dennissinger7880
Жыл бұрын
In another KZread viedeo have same Problem whith one channel . Is cheap but must luck to buy one good amp.
@trungqn1890
Жыл бұрын
@@dennissinger7880 do you remember what youtube channel?
@jezdimir2007
Жыл бұрын
@@dennissinger7880 had a channel issue with mine but found it was the opamp at fault. I do find it's more pleasant to listen to at lower listening levels but gets a little sharp and hissy in the highs as you bump the volume up. Not confident in the quality of the 10uf (printed as 22uf) on the input side or the 1uf 63v monolithics at the output. I think theres potential with this little amp but it needs some experienced eyes cast over it.
Пікірлер: 17
Nvarcher tpa3255 have nice board , same Quality sure electronics:) but more expensive
Bu devrelerin en iyisi hangisi ses olarak.
Bạn cho hỏi chạy được 48v ko ạ, với tại mình có loa kéo chạy 3251, mình thay thành 3255 nâng boots nguồn lên 48v khi hát nhạc ko sao nhưng ca mic lớn bị rè loa kiểu mất sóng micro ấy
@dirceub.r5907
Жыл бұрын
Jovem, Texas Instruments diz que pode-se usar até de 18 até 48v, mas nos anúncios do Aliexpress, diz que uma tensão segura, seria de até 36v.
the project turned out, only the cooling radiator was finalized, the thermal paste was replaced kzread.info/dash/bejne/Yppts9R-nMyskdo.html
hello, how good is this amplifier board?, I am also going to experiment with it, try d class
@trungqn1890
Жыл бұрын
Hi, this board is cheap, low finish quality but sound quality is quiet good
@peshcom84
Жыл бұрын
@@trungqn1890 thanks, I already understood that there can be unpleasant surprises with this board, for example, with cooling, apparently you need to immediately change the thermal paste
@dennissinger7880
Жыл бұрын
In another KZread viedeo have same Problem whith one channel . Is cheap but must luck to buy one good amp.
@trungqn1890
Жыл бұрын
@@dennissinger7880 do you remember what youtube channel?
@jezdimir2007
Жыл бұрын
@@dennissinger7880 had a channel issue with mine but found it was the opamp at fault. I do find it's more pleasant to listen to at lower listening levels but gets a little sharp and hissy in the highs as you bump the volume up. Not confident in the quality of the 10uf (printed as 22uf) on the input side or the 1uf 63v monolithics at the output. I think theres potential with this little amp but it needs some experienced eyes cast over it.