Mr IQ remember safety first. Get a push stick. Your hands will thank you for it. And use a blade guard.

@mr.IQhomemadeDIY

4 ай бұрын

Hello. I always use a saw guard and push rods. This is only for the video, I worked without protection, so that it would be better visible to the audience. Thank you for the tip.

Coloque fita crepe e depois execute o corte. Fica resolvido

@mr.IQhomemadeDIY

4 ай бұрын

Hello. Thank you for your comment

Hi, nice videos, but in this one: how much material is removed with the milling of the third method? (2mm?)

@mr.IQhomemadeDIY

3 ай бұрын

Hi. 1mm. But if the saw is not sharp, then 2 mm.

Why do you have to stack it? Isn't it the same as lowering the blade??????

@mr.IQhomemadeDIY

4 ай бұрын

Yes, it's almost the same. But if the saw does not go down, then this is a good way to get rid of chips

@bennamingismyname

4 ай бұрын

@@mr.IQhomemadeDIY I see. It couldn't be adjusted?

That's not really cutting it without chipping! It's cutting it with chips then removing the chips with a router. You'd have to cut all the pieces longer than you need then rout them to the right size.

@mr.IQhomemadeDIY

4 ай бұрын

Yes I know. Thank you for your comment

hello

@mr.IQhomemadeDIY

3 ай бұрын

Thank you very much for your comment

@DaKeCat-KunLunTooth

3 ай бұрын

​@@mr.IQhomemadeDIY🎉🎉

@DaKeCat-KunLunTooth

3 ай бұрын

@@mr.IQhomemadeDIY

i don't get it

@mr.IQhomemadeDIY

4 ай бұрын

What don't you understand?