I meant to say I can't push in

TS110A pto grinding when engaged. Can you pull the rear cover to repair without many parts coming out? Thanks

@HD_Diesel_Mechanic

Жыл бұрын

Let me look up the TS110a and or look at the one we got in the shop. In the morning. I’ll let you know for sure.

I have a 2004 new Holland tn65 tore it apart and replaced bearing got it back together and now I can push in clutch any thoughts tia

@HD_Diesel_Mechanic

11 ай бұрын

You can’t push in the clutch ?

@HD_Diesel_Mechanic

11 ай бұрын

Which bearing did you replace? Throw out or pilot? Front input shaft? Did you remove the clutch?

@chasityswinney2079

11 ай бұрын

@@HD_Diesel_Mechanic I got it figured out just needed to drive it

I have a question about the pto clutch shaft witch goes on that bearing on flywheel, is the surface of the shaft the same width all the bearing width, or is it wide exactly like the inner bearing race only at the tip of shaft, because i dismounted mine, and dont know if the shaft is damaged, or is it ok

@HD_Diesel_Mechanic

6 ай бұрын

What model is your tractor?

@janko9929

5 ай бұрын

it is fiat 55 86 dtf@@HD_Diesel_Mechanic

@HD_Diesel_Mechanic

5 ай бұрын

@@janko9929 the tip of the shaft should be close to the same size as the inner part of the bearing. Tip of the input shaft should fit into inner part of bearing.

I have same problems with a7040 ford tractor ,it’s same?

@HD_Diesel_Mechanic

3 ай бұрын

It’s a different set up. It has a single stage clutch I believe. I’ll double check

That don’t look cheap

@HD_Diesel_Mechanic

3 ай бұрын

Few $1k