totally nice handling and great video , good job mate ,

Loved the video i have the same hoover, i have a faulty speed controller. 3x repaired the same issue. 4 th time no longer hase the garanee 😢

@proexservis

6 ай бұрын

Thanks 👍 Faulty? Broken regulator or what?

Unfortunately in my case the 4pin push button itself is fine but the plastic mechanical push buttons part that presses actual push button is broken n. Dnt see what could be possible solution

@proexservis

3 ай бұрын

Then you need to replace it, spare part (plastic button on/off) is 8090099022 (if you have same model: UFFLEXA or similar)

I have the same model, I knocked the back after a filter clean to loosed any dust and all of a sudden the suction is now at like 5% .. no idea what I messed up..

@proexservis

10 ай бұрын

Did you try it without dust container? Those 2 hoses (silver/gray - right next to container) have to be on right places, not vice versa (check their seals).

Hi, I have exactly same problem. What is called the part you replaced? Thanks

@proexservis

9 ай бұрын

Hi, push button 4pin, or micro switch

@bulentackyol2927

9 ай бұрын

Thank you

How can I replace vacuum cleaner motor for Z1670

@proexservis

6 ай бұрын

Hello, I am not sure that you have correct model, do you have Product number? Motor for PC1670 is no longer available, you have to pry out on/off and winder buttons and there are screws, then you should be able to open motor holder.

How exactly do i find this push button. I have exactly same hoover with exact same problem

@proexservis

3 ай бұрын

Hi, you can replace it with new 4pin switch (soldering is needed). Or just replace spare part, look for Part Number: 1181968031 (switch board)

@Faheemyoutube-qb4cx

3 ай бұрын

Thank-you fornquick response. I opened and saw button itself is fine but the plastic push part that presses push button is broken. Tried to glue it but it wont hold

@proexservis

3 ай бұрын

If you have same model, then plastic button is 8090099022

I failed to turn the catch! 🥵

@proexservis

2 ай бұрын

Hi, try to put flat screwdriver between vacuum body and that silver ring (from top left - if you are looking from front on that ring, it is on 10 o’clock), pry that silver plastic with left hand, with long pliers hold silver ring on 7 o’clock and push it down (you have to stand over top of the vacuum cleaner, so you can use your weight and vacuum cleaner will stay on place, you dont need 3rd hand and you can push it harder) - by this way you will probably scratch this silver ring with pliers but it will be on bottom of that ring, so it doesnt matter, i think 🫣

Bollocks to that. Just buy a new one.

@proexservis

10 ай бұрын

That 4pin switch cost few cents, or few euros if you buy whole switch unit 🥲