Check out the Nitride here: www.amainhobbies.com/elceram-nitride-1-10-brushless-lcd-display-esc-elcnitride110/p1531651

Imagine castle did this with a 12s esc. Next level

Should make a 1c version for carpet oval class to

That’s sick ❤

Can't decide on this esc or the G2S. I already have the hobbywing ota programmer so the programming isn't an issue for me

If motor or batt wires are cut to short or go bad cant replace

What’s refresh rate should I set my Rx channel output for this esc?

Peut on conserver les différentes courbes et informations du run en mémoire ?

put this esc in my b6.4 it is money !!!! 🏁🏁🏁

@AMain_Hobbies_2

5 ай бұрын

Great, happy you're lovin' it! -Brett

@LegendsPizzaCo

3 ай бұрын

I have a B6.4 as well. Was deciding between this and the Xr10 G2S. I have the ota programmer already since I run hobbywing esc in most of my cars. I cant decide which to buy. On one hand I trust hobbywing and their products. They are built good and last a while. ELCeram is new to me and I can't speak for their customer service or quality od their escs. I'm torn tho cause this screen is nice to have for immediate info. My hobbywing ota gives me all this information as well just takes an extra step. Have to plug the programmer in and load the app. Its not that hard nor does it take that long. So I'm torn between these 2 escs lol

Setting for drift....?

how does trapping all the heat at the bottom help cool it off? especially when the heat is created from above???

@rocketpunchrc7143

2 ай бұрын

Thats were the FETs are to make room for the screen

How much 300 dollars I bet

@AMain_Hobbies_2

7 ай бұрын

It's under $300 but close to it. -Brett