The Light is at the End of the Tunnel...Vinyl Siding Install Part # 2
Тәжірибелік нұсқаулар және стиль
In this video I install the starter strip for the vinyl siding, and then begin the process of installing the actual vinyl siding. I go over my materials, the tools I am using, and show how to measure, cut, and nail vinyl siding. I hope you enjoy and thank you for watching!
SUBSCRIPTION LINK : / @northernoutlier
Music:
1. • ❰Chillstep❱ Sappheiros...
2. • Sappheiros - Fragments...
/ @sappheiros
Пікірлер: 5
What was your reasoning for putting the tyvek over the furring strips?
@northernoutlier
2 ай бұрын
The original tyvek I put on had been on all winter and it was tearing at the top. I think because of having the ladder against rubbing. Thanks for watching.
@johnweninger
2 ай бұрын
@northernoutlier thanks! How has the siding held up being attached to furring strips? I know some have concerns about any waviness due to not having a solid surface behind. We're getting ready to side as well, and I have furring strips over exterior foam.
@northernoutlier
2 ай бұрын
@@johnweninger The siding has held of great. No waviness at all. Just make sure your nailing in the center of the slot, and nailing so it's loose. Leave your gaps on the ends, and only overlap an inch or so and your good. I personally would want that gap just in case any moisture gets behind, then it can breathe a little.
@johnweninger
2 ай бұрын
@@northernoutlier thanks! 👍