Watched this and bought one :) Nice bit of kit! Useful for antenna measurements too.

Thanks for picking this idea up. Gotta get one of these.

It's a really useful piece of kit!

Superb demo!

You might get better results if you adjust the termination values. Right now you're at 50 ohms (VNA), but most filters need something in the 100-500 ohm range.

Another useful vid. Thx Paul. I wonder if it would be same with the NWT500 or so.

@user-xj8oh6fo2f

3 жыл бұрын

Waldemar Antonik Sure it would. You don’t need phase information for such measurement. So not only VNA could do it, but scalar analyzer like NWT would do it with the same results.

ooookay. Why do so many of these videos show the results but NOT how to set the van for thru put and showing what each trace is set to?

Any way to use crytals for a notch filter instead of a band pass?

@vk3ye

Ай бұрын

Yes. Look up old (1940s-50s) communication receiver circuits for the use of single crystal filters with a deep (though uneven) notch.

@t0nito

Ай бұрын

​@@vk3yeThe goal would be to make a narrow notch on 136.7 MHz VDL2 blips because they overload the SDR interfering with APT/LRPT signals from 137.1 to 137.9, but 136.7 is too close to 137.1 so I have no idea how I would solve this. A normal notch has a rather wide drop curve so no way of eliminating or deeply attenuating the interference without affecting the wanted signal

@vk3ye

Ай бұрын

@@t0nito That's too high for a crystal. You need to investigate cavity filters etc as used in VHF repeaters.

@t0nito

Ай бұрын

@@vk3ye I've tried a helical resonator filter, what some people suggest is to downconvert to a lower frequency

Very useful video, but how do I test a filter requiring 800 Ohms termination, can I just add resistors or is the loss too great?

@vk3ye

3 жыл бұрын

I would try some sort of broadband transformer.

1:57 -11dB Is your NanoVNA calibrated?

🙂👍

Now many peoples using it nano vna

I dont think these crystal filters are matched to 50 ohm. Therefore, this is not the correct method for measurement. You need matching

@walterpearce3104

3 жыл бұрын

@@tcarney57 Most certainly, and a great demonstration of how to use a Nano VNA to display various crystal filter configurations, rather than taking precise measurements for designing an actual filter. As a proof of concept it hits the mark! Kudos to Peter VK3YE My NanoVNA-F v3.1 with 4.3" screen has just arrived in todays mail and I'm busting to use it to test my ladder filters (and many other things) as soon as I get up to speed with the Nano's controls. If you're a homebrewer you're lost without test equipment to design and troubleshoot.