Please advise me on how to setup Ikon 2 nitro bailout and Governor on a Raw 700 OS105 spektrum sensor. I’ve only flew heli twice without Governor, bailout worked perfectly. Curves 60 75 90. Plenty of headspeed. Setup governor curves 49 74 85 it has Slow throttle SERVO movement on second two flight modes which I've enabled Governor. So now my bailout have slow recovery back to full speed. Had my first flight with my spektrum dx9 raw 700 OS105 nitro ikon Governor switched on. Couldn't get out of a hover due to serious throttle pulsing. Flicked back into bank/setup 1, Governor pulsing went away. Switched Governor off on all 3 banks. No pulsing and bailout works perfectly again. Also still have no idea how to setup bailout on ikon with Governor. 49 curve is VERY slow speed , sluggish. Tried the advanced Governor menu, selected bailout tab and the ramp up timing etc, Also changed Ikon 2 unit thinking it may have been a malfunction in the unit, no change. I run ikon on 6 of my 10 goblins (Other 4 are BEAST X) and 4 ikons for my other helis (others are Beast x). All electric. Never used ikon Governor due to using 6 tribunus's on my Goblins (others are castle) and mostly Align on my others. Never anything wrong with any esc Governors. I'm thinking I've done something wrong or missed something. I run Highend servos, esc's and motors on ALL Goblins, so it has to be software related on the 700 Nitro. I've bought over 9 ikon 2 recently off helidirect to change from beast x to ikon 2. Ikon is are great fbl, just can't figure out the Nitro Governor and bailout.

I have a Brain 2 BT fbl but it doesn't have that port for the governor. I thought they were exactly the same things but with different names.

Please advised me on how to setup Ikon 2 nitro bailout. I’ve setup governor it has Slow throttle movement. So now my bailout have slow recovery back to full speed. I run Spektrum dx9

I have a Futaba T18SZ and I can’t get the idle switch to control the (flying style setup menu). It stays on setup 1(Default). I set my idle switch to control aux2. But still can’t get the switch to control style setup menu. When I flip my idle switch in the Governor menu, from idle1 to idle2 to idle3,Everything works. Throttle curve is 0,18, 25, 35, 45, 65,100 Throttle curve is 70 across Throttle curve is 100 across Normal Pitch curve 35,45, 50,65,75,100 Idle1 and 2 Pitch curve are both linear