The thrust race with the small hole goes next to the bolt head as it is the stationary one. (it turns with the bolt, the other one turns with the out drive thus the larger hole for clearance)

@TeamRC3D

Ай бұрын

Yes can see the logic

its posible to just use grease in the gear diff to get it a smoth as a ball diff but the strenght of gear diff. its done in old school cars and works just as good in newer cars but tend to be a forgotten knowlage.

@TeamRC3D

Ай бұрын

But then you cannot tune the diff with different weights?

@mikefleek9259

7 күн бұрын

@@TeamRC3D exactly, the grease will also heat up, thin, and change viscosity ( this depends what type and grade of grease. With Silicone diff fluids, immense tuning possibilites.

1:24: prototype active caster setup

Paint brush for grease works nice.

@TeamRC3D

2 ай бұрын

Thanks for the tip!

How is done the adjustment of the differential?

@edmundooliver7584

2 ай бұрын

by feel and sound

@Synic08

Ай бұрын

Annnnd tighten or loosen the nut through the center…

Slipper pads are thicker on the b7d

@TeamRC3D

2 ай бұрын

In our kits they are not