Un génie, j'adore, toujours satisfaisant ces vidéos, good job.

Bonjour j’aimerais savoir quand je vais récupérer ma console , je l’ai envoyé le 31 janvier

Hello friend, a question, in the photo you put at the beginning, the ones that are not marked, what function do they do?

😆😆👍👍👍👍

Impressive. Is that coated(enameled ) wire or pure? and what is its diameter. I wonder how solder balls touched the board properly with that wire.

@FranceRipair

8 ай бұрын

It is enameled obviously. The board made a connection with the wire that made a connection with the chip at the very least. Most likely that the board also made a connection with the board itself.

hmm... I think I might try this. I have a custom 0.6mm board to go between the main board and emmc, that breaks out a few of the points, dat0 and clk being two of them. I ruined the clk point on my first chip attempt (before I had a better microscope) much like the one in this video. Was successful on my 2nd try, but the first is still laying around to be used later for parts. Would be a bonus if I can get it working...

Hello, sorry for the question, but, this break in the track, results in the console not being able to enter the system, like, just give a Nintendo screen and not enter the system?

@FranceRipair

5 ай бұрын

The console is unable to turn on when the line is cut off.

I connecte the dat0 to point B and now my switch OLED don’t boot ofw ( black screen ) and no boot CFW ( black screen ) do you have solution ? Thanks

Bravo Du coup tu va lui pucé maintenant quelle est reparé

@FranceRipair

8 ай бұрын

C'est l'idée oui ;)

How much does this particular job cost?

Quanto Graus sobre o eMMC?

Extremely dirty work and workplace.

@FranceRipair

6 ай бұрын

Thank you for your useful comment and advice !

SCAM

@shuffle-fichra7377

2 ай бұрын

Pk

@real_synthax

Ай бұрын

the fuck are you talking about lmao