I’ve had the same customer service experience with Myron with Zuks Offroad. He is always super helpful!

@redeyecafegarage7484

28 күн бұрын

Yeah those guys are great!

This is going to be so cool when you’ve finished the swap. That bracket for the transfer case looks sweet.

@redeyecafegarage7484

Жыл бұрын

Thank you!

Looking good 👍 definitely looking forward to more updates on this project 😊

@redeyecafegarage7484

Жыл бұрын

Thanks! I appreciate it! 😊

Wow Seth, a lot accomplished, so nice you found aftermarket parts with top notch technical support. Genius, that's great another step completed. Great job!

@redeyecafegarage7484

Жыл бұрын

Thank you!

Looking great!!!

@redeyecafegarage7484

Жыл бұрын

Thank you! Cheers!

Oooooihhhhh yeah...u- tube vids...now a grad of You tube University!!! Lol!!! Great vid n good instructions!! 👍🐺🧙‍♂️🦊👍

Getting closer…!!!

@redeyecafegarage7484

Жыл бұрын

One piece at a time! 👍

Best part was the bullet removal. Right after that most important, the rear seal is not flush it is depressed below flush.

@redeyecafegarage7484

Жыл бұрын

Thanks again for your help!

I always say "don't worry about extra parts. You'll find out at 80mph what it was for."

@redeyecafegarage7484

Жыл бұрын

High performance weight reduction 😅

Sir need suggest i am going to install 35 tyre those 6.5 can pull easly 35 inch tyre or not

I like the that bracket. U got any details on building it? Obviously saves u from having to use an intermediate shaft. I thought of doing that but wasn't brave enough so I just shortened the shaft and made a stubby. Would still prefer to have no shaft and a shorter drivetrain.

@redeyecafegarage7484

Жыл бұрын

Thanks! Yeah a shaft wasn’t an option for me since my jeep is so short. I used a pre made transfer case girdle as the foundation. It helps that the rx7 uses a slip yoke so I had a lot of in and out wiggle room. Then it’s just a matter of indicating perfect center and tack welding it very carefully and slowly as to not heat and pull things out of alignment. It’s not the hardest thing in the world but it is tedious. But making a proper traditional coupling shaft that is true and balanced isn’t easy either. 👍 I’ve got a bunch of miles on this and so far it’s working well.

Hello Seth may I ask you what kind of flange/adaptor is that between the trans and the case!?

@redeyecafegarage7484

Жыл бұрын

Hi! It’s a custom part I made for this swap. 👍

Sir where from buy

one question can you use the stock transfer case lever with this kit

@redeyecafegarage7484

Жыл бұрын

Yes you can use the stock single stick. 👍

Sir need help i put 33x12.5rx15 tyre in samurai lot of body roll respond but when 31 installed nothing happened what should i do sir suggest

@redeyecafegarage7484

Жыл бұрын

Sway bars 👍

😁👍

Hi sir i am from india and i wanna put this also where fro buying and its availaible in india

Sir one more quation 6.5 purpose for speed or anything else

@redeyecafegarage7484

Жыл бұрын

The low gears are for control and torque off road on technical obstacles