✨✨ Grab our membership for only $1: makersgonnalearn.com/dollar-deal/?el=YT ✨✨

I wanted to tell y’all, because Tanner said he wanted to try B’s tees sublimation paper, that I had actually bought it and got it just bought it about a week or so before he said that and I wanted to share my experience. The colors are amazing! However, I pressed for the normal time and temp but the ink literally went all the way through my sweatshirt, and through my butchers paper and onto the backside of my sweatshirt ruining it! The colors are so vibrant for my tumblers whenI use it though! So it’s great for tumblers, but I will never use it for my clothing again. The colors are definitely so much more vibrant, but make sure you double or triple up on your paper in between your fabric! It also seems to be thicker paper, so it gets hung up in my printer and causes clots of ink on the edges of my prints too. A-Sub is what I started with and have always used, and will continue to use going forward. I don’t want to have to put that much more effort or extra materials in sublimation if its just going to cost me more time and money!

Really good video but what I didn’t get is do you put the tape side up or down where it’s going to start going into the printer? Where is the tape?

I line up the edge of the tape with the back edge of the film. I don’t put any of the tape on the films print side. It works great without worry of printing on the tape

you can lay parchment paper directly on the print to melt the powder with the heat press and press it all the way down i use paper on top and under the film to protect my press from ink and press , it melts it in seconds the parchment paper peels right off no damage to the ink print than repress film to garment its really great it also seems to make it a smoother print on the shirt for both polyester and cotton .

I use DTF a lot; love it! Question though... I sublimate canvas tote bags using my sublimation printer, A-sub paper and my heat press on sublimation-ready totes. BUT - I keep ruining them! I'll forget and put the design upside down, or off center, they're faded or they ghost. HOW - if possible - can I get the sublimation ink out of the bags so I can reuse them? I've ruined 12 bags in the last couple of weeks! 😲😲😲 If I can get this ink out of the bags, I can use DTF on them to redo them or re-use them. Thanks!

Do you have a link to the adhesive sublimation spray?

What sweatshirt did u use? Is it polyester?

Did you try going to wic support i think it is and taking your firmware back to an older version?

Great tutorial! What temperature did you press the transfer on?

@shannonhallum

9 ай бұрын

385°

Hi, what printer did y’all use for dtf print? T.I.A

Love the videos, but please slow down.

I’ve been sublimating for 2.5 years

Can you guys do a Même

Why not use a blow dryer or a heat gun rather than the heat press for the DTF powder?

@desertlilacboutique8045

8 ай бұрын

Because you need even heat at a certain temp. Blowing air might also blow the powder off

Lola

As a grandparent I’m called MEMOM

Is this a new video or a repeat?

@karlaroberts6754

11 ай бұрын

To me, this looks like a mash up of different older videos to make a "new" sublimation hack video.

Its actually direct to film not fabric, direct to garment is direct to fabric.