Thank you for the kind words. The new brake setup is fantastic! Couldn't have done it without your help and wisdom. Thanks as always for being willing to help!

Good info and thanks for lookin out for our safety!

Great new video Walter. Love the hands on video and all the explanations. Did the same job with my Harbor Freight press, after some tweaking I didn’t have to remove the studs.

@TheGT350Garage

2 жыл бұрын

It occurred to me that I hadn’t done a set in nearly 10 years after I did this, and there are other ways to set up the press plates and bridge the bearing plate, but this worked adequately.

Good stuff brother.

Best video on that topic that I have seen so far, thank you 🙏! Have subscribed! Would I need a 20 ton press or would a press with 6 tons or 12 tons fullfill also my needs?

@TheGT350Garage

7 ай бұрын

A 12-ton will install most axle bearings adequately, but can be a little insufficient when removing them. Larger (wider) bearings like those found in trucks can be more difficult and sometimes it’s easier to use a cut off wheel to remove a section of the outer race and a roller, then split the inner race for removal.

@blackforestvintagefords7872

7 ай бұрын

Thank you for your advice. So I will look better for a little more headroom and leaning towards a 20 ton press 👍🏻

WHAT if I dont have a press?? Can you use a piece of pipe to gently drive them on?

@TheGT350Garage

Жыл бұрын

Not recommended. I’ve seen them put in an oven to make them grow enough to reduce the press fit, but you risk damaging the seals and pushing out grease above 250°F. Rent a press or pay someone who has one to do the service if need be.

Knocking the ring off is a lot easier if the axle is about waist high. Set the axel on a vice mounted over a leg of a bench, use a bigger chisel and a bigger hammer. You don't need to drill the ring. Just hit it like you mean it.

Without the retainer plate what keeps the axles from sliding out of the housing?

@TheGT350Garage

Жыл бұрын

The axle bearings were changed during a conversion to Wilwood rear disc brakes. They use a C-shaped caliper bracket that retains the axle. It simply slips over the axle during installation. Thought this was mentioned in the video.