Short,simple...to the point....is one of the best woodwork video

I love how straightforward this video is!

Damn this is super helpful. Im making a video and the ribs need to be bent, but I dont want to buy $100-200 bending iron.

This the second video I watched on this subject. It turns out I wasted 23.34min on the first

Short and sweet!

how much it must boil , and how much it must stay in pose after banding ? ty

that was surprisingly easy

❤❤ thankyou this is perfect

thanks for a great technique

@make_it

7 жыл бұрын

+niks ozarde you are welcome.

@make_it

7 жыл бұрын

+niks ozarde you are welcome!

@aponcapone

6 жыл бұрын

When do you take the bendid wood off the thing you taped it on? Till its dry?

How minute steam Wood for Bending, if Wood 1 cm thickness? Thank you

is this same for very thin wood?

Did you do 100C for 45 min? How would you do 36" long balsa sheets? Thanks.

What is the thickness and width of the wood?

where can i buy this type of wood panel tho

👍👍👍👍👍👍👍👍👍

Pěkné.. jaké to to je dřevo?

@make_it

8 жыл бұрын

+Harry Barry jasan

@bellax6639

7 жыл бұрын

twitter.com/e93928036d8b1c190/status/719079525670395904 tо get reаl frее gamеs Stеаm bending wоod nо sррреciаl toооl neeedеd

Bravo!

Doe this work for plywood? Balsa wood? Or any type of wood?

@Rai2M

6 жыл бұрын

Dont try this with plywood (formaldehyde is the bitch). For a piece of plywood you can easily use kerf bending.

@tobyque9399

6 жыл бұрын

Rai2M Thanks, that's great help.

Could we at least, please know WHAT TYPE of wood you just used? Thanks!

@make_it

5 жыл бұрын

Ash wood

@Sirusdark

5 жыл бұрын

Thanks!! @@make_it

Can you bend mahogany with this method?

@mozarth

3 жыл бұрын

Any wood can be bent with steam, the success rate and the difficulty will depend on the grain density, direction, type of cut and so on.

Thank you.

How about sticks?

What kind of wood is this?

@make_it

6 жыл бұрын

Ash wood

No special tool needed... except for whatever the hell that thing is with the knobs that he put the friggin' wood into ...

Time to make a bow.

Except a canning pot is actually a special tool.

@ripkimjonghyunyoudidwell.9964

6 жыл бұрын

fisharmor could you not do this with a pot and cup at home ? Or maybe use a steamer.

@MattJonesYT

5 жыл бұрын

@@SimonWoodburyForget You can just put a lid on the normal pot. Lots of steamed wood is not done under pressure.

very thin plywood. i will bend it without any heating.

No special tool needed: Then he immediately puts it into a special tool. What a SPECIAL TOOL you are.

@make_it

6 жыл бұрын

You can can use any common kitchen pot, or not?

@julianramos6830

6 жыл бұрын

Sheet, he got you XD

@make_it

5 жыл бұрын

Just a canning pot