Stair Transformation: DIY Porcelain Tile Makeover with Stunning Lighting Effects

Тәжірибелік нұсқаулар және стиль

Covering the stairs is a new project that my father and I did together.
7 years ago, the rough concrete of the staircase was finely treated with a cement screed and prepared for the final final coating with exactly defined tread widths and heights. After that, the treads of the stairs were painted with concrete paint and temporarily covered with carpet.
Considering that the upper half of the house is completely finished with gray laminate, I was looking for a similar solution for the staircase, so we finally decided on porcelain tiles in imitation of wood. The dimensions of the ceramic are 60 x 120 x 1 cm and it is laser cut, so it can be installed without joints for some larger floor surfaces. In the near future, the ground floor will be renovated in a similar tone, so everything should eventually look like one unit with a more modern appearance.
You can also see the lighting of the staircase, which I was very proud of at the beginning, but now I am of the opinion that maybe it is too little. Given the option to do it again I would probably only work on every other tread and landing, I think it would have a much better and more moderate effect. Also, my wish is to install light bulbs with white rosettes, because that way they will fit better into the planned fence and the rest of the interior decoration. And you will be able to see all that in the following videos.
In addition to the entire process of gluing and covering the staircase with porcelain ceramic in imitation of wood, in the video you can also see the improvised rehabilitation of the landing of the stairs and several treads, where the concrete liner miraculously separated from the load-bearing concrete, although we did it extremely meticulously at the time. I decided on this now purely to neutralize the "cavity sound" under the tiles. I must say that we took care of that and thoroughly cleaned and dusted the supporting concrete and applied a strong cement spray mortar as a connection to the cement screed, but somehow that sound of the separated cement screed appeared again, which we have now eliminated.
I hope you like the video, so if you have any questions feel free to ask in the comments below the video, see you again soon.
Like and subscribe.
Instagram
/ herr_ramitch
If you would like to support my KZread channel with a monetary donation,
you can do so via the PayPal link below:
www.paypal.me/SemirRamicYT
Thank you for your attention.

Пікірлер: 20

  • @petarperovic
    @petarperovic23 күн бұрын

    Odlično odradjeno 👍!

  • @vpikooorka
    @vpikooorka7 ай бұрын

    Чудово зроблено. справжні майстри

  • @semir_ramic

    @semir_ramic

    7 ай бұрын

    Thank you!

  • @user-td3pe3ui7c
    @user-td3pe3ui7c10 ай бұрын

    Браво

  • @otorinolaringologija1490
    @otorinolaringologija1490 Жыл бұрын

    Vrlo pedantno, svaka cast.

  • @semir_ramic

    @semir_ramic

    Жыл бұрын

    @Otorinolaringologija, trudio se stari maksimalno kao i uvijek, hvala puno!

  • @mp3dekor178
    @mp3dekor17810 ай бұрын

    Odličan posao !!

  • @semir_ramic

    @semir_ramic

    10 ай бұрын

    Hvala puno!

  • @ivanzivkovicharmonika
    @ivanzivkovicharmonika Жыл бұрын

    Lepo ispalo.Bravo👍

  • @semir_ramic

    @semir_ramic

    Жыл бұрын

    @Ivan Živković “Harmonika”, hvala puno druže!

  • @ibroibrovic2403

    @ibroibrovic2403

    9 ай бұрын

    Pa nije bas ispravno dze ide silikon on stavlja fugmasu.

  • @vladostevanovic356
    @vladostevanovic3569 күн бұрын

    Da li je za pocetnika lakse raditi s tim plocicama msm Na dimenzije i da li si negdje vidio da su cela stepenika jedne boje a gazista druge Hvala na odg.

  • @muamerjasarevic3630
    @muamerjasarevic3630 Жыл бұрын

    🔝🔝🔝

  • @semir_ramic

    @semir_ramic

    Жыл бұрын

    @Muamer Jašarevic, hvala bruda

  • @d6ic374
    @d6ic374 Жыл бұрын

    Brko je majstorčina.

  • @semir_ramic

    @semir_ramic

    Жыл бұрын

    @s3st1c, hvala puno!

  • @Restyle23
    @Restyle237 ай бұрын

    Zdravo, pitnjance jedno, koji diks koristite za rezanje plocica? Ima li nesto povoljno a da sluzi za jedno postavljanje plocica kod kuce?

  • @semir_ramic

    @semir_ramic

    7 ай бұрын

    @Restyle23, koristili smo takozvanu dijamant ploču za brusilicu, koštala je oko 33-34 KM, nije loša al opet smo morali malo pažljivije raditi jer su pločice bile prilično tvrde

  • @Restyle23

    @Restyle23

    7 ай бұрын

    @@semir_ramic Hvala na odgovru, znam da je tzv. dijamantna, ali odem u shop, kad tamo 40 vrsta, od 8KM do 100KM. :). Treba bi nesto povoljno sto ce izrezati 30 plocica, a posje da se baci :)

  • @semir_ramic

    @semir_ramic

    7 ай бұрын

    @@Restyle23 pa onda najbolje tako nešto oko 15ak KM, možeđ čak i jeftiniju pa probaj kako će sjeći, najbitnije da ima dobar rez i da ne otkida gledj pločice jer poslije bude ružno kad se fug masa zavuče u te pukotinice. Ako nisu puno velike pločice najbolje ti je posuditi od nekoga mašinu za sječenje pločica ili ih sve odnijeti pa isjeći na mjeru

Келесі