Speedqueen TR3 Tub Seal Removal

I removed the tub seal on this SQ TR3. Subsequent to this video I installed a new seal but the repair was not successful because I did not recognize that missing pin on the outer tub that prevents the tub seal from spinning was so important. The machine started to leak at the seal again after a couple washes. Replacement of the outer tub is required. I have replaced the entire machine with a Maytag Commercial Washer.

Пікірлер: 5

  • @eldoradoboy
    @eldoradoboy11 ай бұрын

    machine that new I wouldve called SQ on it and had a chat.. couldnt have been that far out of its warranty I have a TR7 that seems to get the job done.. though I tend to like the traditional SC5 wash action better.. fortunately no leaks yet..

  • @petermaz701
    @petermaz701 Жыл бұрын

    Wow, that was way too much work. I can’t believe it. It already started leaking.

  • @sunshine4530
    @sunshine45304 ай бұрын

    Why did you decapitate the machine ? You can just hold the top up on its hinges. It stays in place if you leave the lid open.

  • @tterwe
    @tterwe Жыл бұрын

    Good vid but not enough swearing.

  • @hughbrian1118

    @hughbrian1118

    Жыл бұрын

    There was much swearing. The TR3 was an utter disappointment compared to my first SQ that is still going at a friend's house.