Sonoff SNZB 04 unbox and add to Home Assistant
Ғылым және технология
My first video, so it's rough. I am unboxing a Sonoff SNZB-04 Window/Door sensor. It operates on the Zigbee network. After unboxing adding it to Home Assistant via the ZHA integration and a Conbee II USB stick.
You'll be glad that I don't follow Paul Hibberts lead with the Home Assistant thrusting!
I am still learning the whole video creation so this is rough but hopefully it works for someone.
Пікірлер: 24
Battery: I think most Chinese suppliers put the 2032 battery in. Hence the lose connection. Like you stated: The CR2450 type supposedly is the correct type which is more expensive and therefore not supplied at all times. I did not check but I suppose, it's not only about more capacity but also thicker.
@marklewis5460
2 жыл бұрын
I did buy some 2450s but think they were physically too big for it in the end.
In my HA I can add the device but it does not respond with open and closed iaszone status. I have two and neither work, while contact sensors from other manufaturers are fine
@marklewis5460
Жыл бұрын
I had issues where it just stopped responding. I could add it and then it would never show as open/closed. I ended up replacing my Sonoff with Aqara which have been reliable.
Shame you missed out the step showing how to put the device into pairing mode.
@marklewis5460
9 ай бұрын
Apologies, because it was an unbox it was in pairing mode straight out the box. There is a small reset pin (like mobiles) that you can press & hold to reset
the bloody thing doesn't work for me. ZHA does not find it. what am i doing wrong?
@marklewis5460
Жыл бұрын
Not sure why ZHA doesn't find it. Are you close to the hub/USB stick? Do you have powered devices extending your zigbee network?
@JoeyPat83
Жыл бұрын
i ran into the same issue. when you pull the hardware out of the case, you can find at the battery side a small button which could be used to start the pairing process. this worked in my case
@dev0173
Жыл бұрын
@@JoeyPat83 You can access that button via a small hole in the case too. Press for 5 seconds to put it into pairing mode. There's an LED visible through the case that should flash 3 times to confirm.
Compared to the aqara ones these are ultra garbage.. battery life is really bad
@marklewis5460
9 ай бұрын
I do prefer my Aqara sensors. I have found them more reliable than the Sonoff.