So helpful, thank you so much.

I had a doubt ... after you insert the impeller and inducer combination you need to also design a casing for it how do you do that , like you can't just keep the impeller free ...it needs to have a casing

i cant thickening my volute. any ideas?

Im following the steps, but after i try to thicken, it cannot because of open surface appear at plane 1. Why it happen? Help

@hanidaradkah8973

2 жыл бұрын

For me, It refused thickening of 3.5 mm. But for 1 mm thickening, it works since I selected inner thickening.

So slow, so un-manufactureable, and that tongue ever hear of stress concentration? Rarely are symmetric volutes used in industry. A better method which should take far less time is pattern create planes create one sketch, copy to planes and create design table for variant radii. This would take 5 minutes, not 30

@polipochilegge

2 жыл бұрын

can you explain better or link some resources about this method you proposed?

@Michallote

Жыл бұрын

Thought the exact same thing, looks like a very amateur way to do it.

@DR-br5gb

11 ай бұрын

@@polipochilegge No he can't. He's cucking his wife currently