Solidworks simulation tutorial | Structural analysis of shaft and pulleys

The 1.5-in-diameter solid steel shaft is simply supported at the ends.
Two pulleys are keyed to the shaft where pulley B is of diameter 4.0 in and pulley C is of diameter 8.0 in. Considering bending and torsional stresses only, determine the locations and magnitudes of the greatest tensile, compressive, and shear stresses in the shaft. Compare solidworks simulation results with hand calculation.
Download shigley book from this link.
www.dropbox.com/s/ywid8vh0e2o...
----

Пікірлер: 15

  • @cad4fea
    @cad4fea3 жыл бұрын

    Thanks

  • @bubblesm982
    @bubblesm9823 жыл бұрын

    Hello can u explain how to remove the diameter in 3:80 bcs i am not able to sketch the circle

  • @deadline8661
    @deadline86613 жыл бұрын

    Nice Thanks for your effort

  • @cad4fea

    @cad4fea

    3 жыл бұрын

    Good

  • @mustafaercumen3187
    @mustafaercumen31872 жыл бұрын

    How can I add Weldments button into my screen? I can't find it

  • @Ryohgantz
    @Ryohgantz3 жыл бұрын

    Very good explanation 👍👍👍

  • @cad4fea

    @cad4fea

    3 жыл бұрын

    Thanks for your comments

  • @cad4fea

    @cad4fea

    3 жыл бұрын

    Thanks

  • @sylvaincote2762
    @sylvaincote27623 жыл бұрын

    you did not considered the torque created on each pulley by the unbalance forces.

  • @cad4fea

    @cad4fea

    3 жыл бұрын

    Please follow next

  • @rezataherpour1002
    @rezataherpour10029 ай бұрын

    Everything was good there is only one question Your cross sectional area is 4.75 In^2 if you divide it on 30 inches , length of the whole shaft, it gives you 6.5 and it is less than 10 means 10 times smaller than the length and with this in mind you should treat your beam as Truss element why did not you choose Truss on your Cut list before simulating?

  • @cad4fea

    @cad4fea

    9 ай бұрын

    Thanks for watching

  • @rezataherpour1002

    @rezataherpour1002

    9 ай бұрын

    Please answer my question dear designer @@cad4fea

  • @xyengineeringandtechnology8497
    @xyengineeringandtechnology84973 жыл бұрын

    Thanks

  • @dellpi3911

    @dellpi3911

    3 жыл бұрын

    kzread.info/dash/bejne/e5Wiybp6c6m9ZJs.html

Келесі