your videos are so detailed thanks a lot

great. thanks :)

Thank u so much man u helped me relearn sheet metal for my interview, hopefully i get it man

@CADCAMTutorials

2 жыл бұрын

You're welcome 😊 and all the best for interview.

for solidworks recommendations which year is best for use?

When I tried the first part of changing the bend radius, it was brining rebuild errors. I fixed it by changing the bend allowance to 0.5 K factor. It was already there in yours but for new installs, it might not be the case. ;-)

@CADCAMTutorials

3 жыл бұрын

Thanks for update.

Super helpful thank you

@CADCAMTutorials

5 жыл бұрын

You're welcome

U can do offset bend in place of sketched bend

Hi, Is there another way to make this 3d from straight 2d drawing using SKETCHED BEND tool in SHEET METAL?

for the sketch bend I can only get as close as the inner of the flange being 20.15mm from the top edge anyone else have this issue? have played around with the position options for the flange and the sketch bend

@redcoatgaming3682

Күн бұрын

Same here

Thank you sir

@CADCAMTutorials

Жыл бұрын

You're welcome 😊

Hello sir, could you please tell me where do we get these kind of practice drawings

how about the K factoe

what year did you use solidworks for? why it's so different from 2018

@husnibakhtiar502

5 жыл бұрын

Answer please. for solidworks recommendations which year is best for use?

@dannyloader9012

4 жыл бұрын

@@husnibakhtiar502 use the latest.

@Pandorarl

3 жыл бұрын

2016

When i attempt to propagate the edge flanges, it doesn't work. It only works on 1 edge.

@redcoatgaming3682

Күн бұрын

Same problem

@davethel86

Күн бұрын

@redcoatgaming3682 I found that you have to make sure you're drawing the line on rear edge once normal to view is selected

@davethel86

Күн бұрын

@@redcoatgaming3682 you have to make sure that the lines you draw are connected to the rear after normal to is selected

Make it slow man