[Small desktop lathe] CJ0618A Align cross slides [Hand Scrape Metal]
Тәжірибелік нұсқаулар және стиль
Hand-slide the cross slides of a small desktop lathe.
0:00 Cross slide alignment
0:22 Current status of cross slides
1:14 Cross slide structure
1:55 Slide disassembly
2:51 Checking the horizontal feed table
3:21 Checking the top feed
4:00 See the distortion on the stone surface plate
4:37 Sliding with a stone surface plate
6:59 Machining of top feed base
8:35 Top feed table sliding completed
9:12 Processing of horizontal feed base
11:56 Horizontal feed base base measurement
12:24 Horizontal feed table processing completed
14:17 Check for rattling of the horizontal feed table
16:18 Check for rattling on the top feed table
17:31 Before * After of the tool post
Пікірлер: 8
これこそ職人、参考にさせていただきます!
@engi-nin
4 ай бұрын
コメントありがとうございます 職人だなんてとんでもないです(^^; 素人なので、少しずつ削って1カ月以上かかりました
@user-xt2gk1st9i
4 ай бұрын
えんじにん様 「素人なので」とおっしゃいますが「素人」がすり合わせまでやりますかね?大体、開封・(ガタの調整)簡単に削ってご視聴ありがとうございました・終ですよ。私も近々卓上機を考えてるのでその時は是非参考にさせてもらいます。勉強になりました、ありがとうございます。ご安全に!
やっていることは、事実上の人間平面研削盤&きさげ加工ですね。 一人前になるには、10年はかかるとか。
@engi-nin
2 ай бұрын
コメントありがとうございます 私は、これだけでお腹いっぱいになりましたが(^_^;) 何年も技術を磨く職人の方々には、尊敬しかありませんm(_ _)m
卓上旋盤の再生リスト全部観ました。 めちゃくちゃ面白かったです。 最近卓上旋盤を買ったんで、勉強になります
@engi-nin
2 жыл бұрын
コメントありがとうございます そう言ってもらえると嬉しいです
🤩