Sled Mods Part 3 Finishing up the Ice Age Khaos conversion on the RMK Pro
Фильм және анимация
Fixing my mistake from earlier and drilling out the correct hole for the Ice Age Elevate kit. It turns into a shindig but we wrap up the entire Khaos conversion and the Ice Age Elevate set up. Ready to cut the tunnel next.
Пікірлер: 21
Wahl Brothers has a solution in the way of a bolt on adjustable mounting plate which allows the front shaft to be adjusted up or down.
It actually doesn't look too bad once you painted it. I bet if you sanded a bit, put a film of JB weld, and sprayed it lime green with a rattle can it would almost be factory, lol. This is the perfect situation for a dremel with a small grinding bit. Could have made a perfect notch for the bolt head in the board. Nice job though!
i would recomend getting 6-8" of aluminum solid roll. pull the plastic end caps off the boards and hammer it in from the front to bring somestrngth back in the boards as id be highly concerned about a chassis failure to due flex on that board. sharp buggy
@themediocregarage
2 жыл бұрын
That’s a good idea actually. I might have to try that.
that SQUARE tho....
@themediocregarage
2 жыл бұрын
She’s a much bigger ongoing project lol
@2:34 i in the past liked to (always have) switched to longer m12 10.9 8mm hex bolts. soak them in oil after heating to blue if a bit of rust bugs you. You can run stainless. you can run titanium. But im 220 and like to abuse shiisleds ehh
Did you use the stock bogey wheels in the rear?
@themediocregarage
Жыл бұрын
No the Ice Age rails are cut for an 8 inch bogey wheel so the stock 7.25 inch ones won’t work. I just purchased the 8 inch ones with the rails.
Find an Allen head bolt
@themediocregarage
Жыл бұрын
Good idea! I’d definitely try that if I did this again.
As much money as you have in the Iceage set up you should have just sold it and, upgraded to a new Khaos matryx...the matryx platform is soooo much better!
@themediocregarage
2 жыл бұрын
Next year… next year lol
@briandhoward6137
Жыл бұрын
Good thing he didn't do that, he would not be riding this season with all the stop ride recalls. Ugh Polaris is killing me
@hornefoundations
Жыл бұрын
@@briandhoward6137 Lol..I hear ya...gotta keep the old one (even though it's recalled). Hopefully Polaris steps up thier reliability game...as reliability is by far the most important part of a machine while riding.
@briandhoward6137
Жыл бұрын
@@hornefoundations agree, I sold my 2020 Khoas and 2 days later my dealer hit me with the 1st stop recall and now a second one. Ugh
Any vid of ridding it
@themediocregarage
Жыл бұрын
Not much no. Hoping to get set up for more riding footage this year.
Why didn't you just modified bolts? 🤔 wtf
@themediocregarage
2 жыл бұрын
What’s your idea for modifying the bolts? I can’t picture how to modify the bolts to solve the problem.