My 2012 Honda accord was diagnosed with the u1055 code ECM and the lights are popping up for the TCS, ABS and handbrake light. What do I check and have to fix, to get those light to go away? Can I drive, without issues?

Thank you❤❤❤❤

@8020Media

15 күн бұрын

M - Thanks for the feedback! Hope it helps.

I was getting an electrical burnt smell in the car. With an ALT overcharging, this fried many things in the system.

@8020Media

10 күн бұрын

C - So sorry to hear, hope you got it fixed!

I believe my ecu/ecm is failing on my 18’ camaro throwing all those codes and giving a list of faulty sensors. Is it better to replace ecu first rather than going down the list and fixing all the list of codes? Ive replaced a couple of the codes like spark plugs, 2 ignition coils, and has fixed the misfires. now giving oil pressure fault sensor. And still idling rough

@8020Media

2 ай бұрын

S - If it was up to us, we would change sensors first as they tend to be cheaper. Keep us updated.

For some reason the check engine light does not come on at all on my car, I have a ‘77 porsche 924 and it does not come on despite my car misfiring constantly. Cant even accelerate/ step on the gas without it misfiring and the car wants to cut off and is sputtering. Any ideas on what it could be?

@8020Media

Ай бұрын

Z - Have you checked for engine codes? This is usually the best place to start for diagnosing.

what would cause a fuel pump to shut off, i have a 2006 ford f150 4.6 it starts fine runs for like 2 minutes then idles down and stalls. the on board system tells me to check gauges, everything seems ok. then i try to star it from that point and it just cranks, no start, but if i turn the ign key to off and it will repeat the run and stall, i took the plug off the fuel pump driver module .and jumped the 2 outer wires and it starts and stays running. can not figure what is going on any suggestions!

@8020Media

15 күн бұрын

G - We have a video specifically on the fuel pump that may help: kzread.info/dash/bejne/lamVmMOAYs_Kaag.html

I recently messed up my truck (2003 Silverado 1500) I connected my light bars positive wire to get power and connected it to my f/pmp relay and while I was doing it my truck shut off and ever since no crank , no start then I moved around the fuses and it starts but the dash doesn’t work and it says low power , when I go to turn off the truck it doesn’t turn off the engine keeps running for a minute then turns off . Any suggestions?

@8020Media

2 ай бұрын

E - Are you getting any engine codes?

@ericjimenez6886

13 күн бұрын

@@8020Media the dash wasn’t working I got my truck back to running good took it to the dealership

@ericjimenez6886

13 күн бұрын

@@8020Media turns out the reason the truck didn’t want to crank and start was because I put to much pressure in the fuel lines and needed to bleed it out got it back from the dealership running but still electrical problems I checked under the hood and a ground was disconnected from the battery. I plugged it back in and good to go my fault for not noticing the obvious

@8020Media

9 күн бұрын

E - Thanks for coming back and updating here! This will certainly help future viewers.

What would cause my ac and radio to be able to turn on without key in the ignition? It's a 2008 pt cruiser 😫

@8020Media

10 күн бұрын

T - Could be a possible bad starter solenoid.

My car engine runs just fine but in the last few years when I’ve gone out to start up it like misfires and the engine light is flashing becomes undrivable. I go inside wait 10 minutes and start it up and it runs just fine. It’s done like three or four times in the last few years.

@8020Media

2 ай бұрын

D - Sorry to hear this.. Are you getting any engine codes?

@jerryshadley8977

27 күн бұрын

Check your spark plug wires/boots for any damage if so replace them, also check your spark plugs for any noticeable damage an if there is replace them. If that doesn't work an ya have one on you use a scanner tool to try and see if any codes shows up.

@8020Media

25 күн бұрын

J - Thanks for the input here.

Would my ecm be bad, I have drove 3000 miles and obd reader says some things are not ready for inspection.

@8020Media

10 күн бұрын

J - This is very vague and we aren't sure how to help. What things aren't ready? What codes are you getting? We just need more information.

@JamesLisbony

3 күн бұрын

@@8020Media I think my ecm is failing. No codes on dash . Everything I take it to get inspected, it doesn't pass . They tell me the catalyst, h2o sensor, and o2 sensor not ready.

@8020Media

2 күн бұрын

J - Have you taken it to a mechanic?

2012 Ram 2500 ST, Crew Cab 4 Full-Size Doors, Four-Wheel Drive, 5.7L V8 Gas---- where can I order a ECU/ECM

@8020Media

27 күн бұрын

B - Have you gone to the dealership? If not, there's a ton of resources online.

@bigbusiness6903

27 күн бұрын

@@8020Mediadealship ? Hell no I know the dealership prices

@8020Media

27 күн бұрын

B - Could give you an OEM part # was our point here.

@bigbusiness6903

26 күн бұрын

@@8020Media I’m so unknowingly thinking at the moment 🥹🥹 I’m not 100% sure of which part to buy 🥹🥹 don’t know if it’s the TIPM -FUEL PUMP - OR ECU/ECM

@8020Media

25 күн бұрын

B - No worries! We hope it gets resolved for you. Keep us updated.

Will this cors the car to over heet

@8020Media

Ай бұрын

S - Not likely.

@jerryshadley8977

28 күн бұрын

no, i'd check your thermostat and coolent temp sensor an depending on vehicle check the radiator fan relays 1st.

@8020Media

27 күн бұрын

J - Great advice here. Thanks for replying to Steven.

odb2 what a joke . misfire ... new plugs , wires , distributor , crankshaft sensor , tps, new injector system , 350 bucks in diagnostic fees .2002 blazer 4.3 engine . ecm or ecu ? which shows gm intelligence they couldnt figure out what to call it. great compression great leakdown test . if the ecm/u does not work i might drive it to detroit and park it in gms lobby.

@8020Media

14 күн бұрын

C - So sorry to hear this..