For the bolts, there’s a little pin icon next to the check/x buttons that allows you to create all the bolts in one go without losing the settings.

@KellyBC

Жыл бұрын

Thanks! That bit of information helps a lot.

At 54:00, it should be e^(Bd/l), like exp(Bd/l) means exponential. You put A^(Bd/l). Otherwise, a great video and a great series.

Nice video,Excellent explanations. I have a question: I don't understand how the safety factor calculated by SOLIDWORKS should be interpreted? Only with the preload I have a coefficient of 1.3. It is therefore impossible to have a safety factor of 2 given the preload. So when do I reach the yield point? the answer is: when the coefficient calculated by SW is 1, Right?

excellent video. thanks for that

@KellyBC

Жыл бұрын

Thank you!

Please make video example for pipeline simulations Calculations: pipeline route study, wall thickness and material grade selection both rigid and flexible pipe, collapse and buckling analysis, on bottom stability analysis, pipeline end expansion, pipeline free span, bottom roughness analysis, lateral bucking analysis, pipeline crossing and its structural supports design, fatigue analysis.

@KellyBC

3 ай бұрын

That sounds great for sure, but is a bit out of my area of experience.

Great, thanks

@KellyBC

Жыл бұрын

You are welcome!

great video thanks

@KellyBC

9 ай бұрын

Thank you!

Curious why not use the yield strength of the bolt instead of nominal I believe it was that you used? Also I was curious as to why you did the little extrusion on the bottom of the top plate to select the specific face? Is there a reason why you wouldn't want to do it with a split line?

That's great

@KellyBC

Жыл бұрын

Thanks!

if only mathcad had that yellow-green hue and the border lines of the best engineering paper: Tops.

Hello What's the name of the book that contains all bolt data tables. Thanks in advance

@KellyBC

2 жыл бұрын

I am using a textbook - Shigley’s Mechanical Engineering Design.

@WeiderMystic

2 жыл бұрын

The Bible of Mechanical Engineering: Shigleys.

nice

@KellyBC

2 жыл бұрын

Thanks!