Wondering how to load the #paperroll Media in #SATO #CLNX Series w/ Rewinder option?
Try the following steps:
1. Open the side cover. Push the head lock lever towards the rear.
2. Pull the media holder guide and media guide away from the printer. Turn the knob counter clockwise to release the media guide.
3. Load the paper roll media in the media holder. Push the roll towards to the printer. Push the media holder guide lightly against to the media roll.
4. Pass the media below the media damper and media sensor guide while pushing the media to inside of the printer. Ensure that the end of the media extends out of the printer.
5. Press the tab at the front of the printer to open the dispenser unit. Remove about 80cm of labels from the liner.
6. Pass the liner through the gap of the dispenser unit to the outside of the printer.
7. Pass the liner below the liner rewinder and attach it with the clip. Rotate the liner rewinder counter clockwise by hand to wind the liner.
8. Adjust the dispenser roll to the center of the label.
9. Press the print head down until the head lock lever is locked. Tighten the label and close the dispenser unit.
10. Press the media guide lightly against the end of the media, and then turn the knob to lock the media guide.
11. Close the cover.
P/S: Use SATO genuine media and ribbons for the printer, for optimum print quality.