I just picked up one at a flea market by accident and they said it was for parts only, no left channel. So I bought it and tested all speaker inputs, A, B, A&B, Left, Right, Front, Back, 2 and 4 channel and they all work, I could not believe it. Phono, Aux, Tape Monitor 1 and 2 inputs all work. AM/FM works. It is very dirty and still needs a diagnostic evaluation and thorough cleaning inside and out and just replace the fuses so its all clean. I have a B&O 2423 ready to be picked up and this will go in next. Your video is very helpful. Thank you!

Hi Andrew. Do you have a vid of the finished product?

I have a qrx 8001 that burns r58 on the left driver card. It is set for incoming of the board, would you know where I should start on this beast

Cool I have a 6001 (working well ) and a 7001 which has one channel not working.Amazing amps. Did you get it working ?? Cheers

@MadScientistsLair

10 жыл бұрын

I just need to upload the vids, I did get it working and the problem was nothing what I expected.

@lampang3

10 жыл бұрын

Hi ... thanks for the update. Curious to hear what the problem was . When working they really are great amps.

Hi Andrew I just bought a 7001 but the rear left channel keeps blowing the fuses when I turnit on,with or without speakers, any suggestions?,I live in Mexico,otherwise I would send it to you, I appreciate any help, thank you

@MadScientistsLair

7 жыл бұрын

Output transistors are probably blown.

Nice and dusty inside (:->

Where are you located? I have a g9700 that the left channel wont work.

@MadScientistsLair

9 жыл бұрын

Bart Lewis Dallas, TX. G9700 is a totally different beast by the way and can be expensive to service. (If they blow up, they *really* blow up!) See my facebook page at facebook.com/AndrewsElectronics The facebook page is monitored MUCH more frequently.

Helllo! I AM looking for 2 drivers board and só far no success. Do you havê spare boards?

@MadScientistsLair

7 жыл бұрын

Nope. You'll need to have yours repaired. Whole spare boards are EXTREMELY rare; repair is the only option available in almost all cases.

@Unavintage

7 жыл бұрын

Andrew, thank you your prompltly response. I´m a prospective buyer of a 7001 and the owner lost both board due to unscrupulous tech, missing with it. Reproduction may be the last plan but demands sikilled professional to do it. Thanks!

@MadScientistsLair

7 жыл бұрын

I suggest using a photographic process to duplicate the solder mask. You'll likely need to depopulate and clear off excess solder on a working board to get a useful image for the mask though.

@Unavintage

7 жыл бұрын

According my research, the QRX design is the same of board driver of Sansui 8080. In my case, it´s easier to find and by new components.

@MadScientistsLair

7 жыл бұрын

Make sure the PCB numbers match. If they don't, beware of possible small differences that may have huge (ie really bad!) consequences if interchanged without making the appropriate modifications.