Great job boys , thanks for sharing your great skills. Hi from montreal Quebec

@twosonssailing

3 жыл бұрын

Thanks for watching! Fair Winds!

Did you deal the edge of the seam afterwards? I just got an old Minifish and the seam doesn't leak, but the edge is just open fiberglass, which in theory could take on water and separate over time. On lasers, they gelcoat over the seam to protect it.

@twosonssailing

3 жыл бұрын

I haven't done much with it yet. If you have bare glass fibers showing you could at least seal them with some unthickened resin. That would keep them from taking up water or stabbing your hands. Many of the Sunfish I've seen have metal trim that goes all the way around the edge, instead of the folded seam like the Phantom, although the later versions did away with it.

@Vok250

3 жыл бұрын

@@twosonssailing the minifish has a folded seam too. I'm probably going to pour polyester resin along it because it's all I can find in my small town. Should be good enough to seal it up.

@twosonssailing

3 жыл бұрын

Just make sure you know of any previous repairs that may have been done. Polyester doesn't adhere well to epoxy.

Hi Nice job. Could you tell the exact type of adhesive used to glue hull and deck. Thanks

@twosonssailing

2 жыл бұрын

I used Thixio, by Total Boat

in the dining room??? my wife would have gone to her mothers!!!

@twosonssailing

3 жыл бұрын

I'm gonna be honest; she was all for it at first, but by week four it was starting to become an issue....

Is max filming?

@paulgraf5259

3 жыл бұрын

As soon as I asked it was obvious.

@twosonssailing

3 жыл бұрын

For most of it, yes. Finn took a turn near the end (where things get REALLY shaky.) Normally I'd set up on a tripod, but this was too time-sensitive to be able to spend time setting up and moving the camera.