New Brake Pads:
Front - EBC FA209/2HH (amzn.to/4bz8OFf)
Rear - EBC FA213V (amzn.to/4ajEfCi)
Tools Needed:
- 13mm socket (amzn.to/4bCDZzD)
- Torque Wrench (33ft-lbs or 45NM) (amzn.to/4dyQAFL)
- Loctite Threadlocker Blue (amzn.to/4bdNBkw)
- Brake Parts Cleaner (amzn.to/3yhCtEH)
- Allen Key or Punch (amzn.to/3JXHbtD)
- Shop Towels (amzn.to/3wuqnrg)
Timestamps:
0:00 - Preparation
2:19 - Front Caliper Disassembly
6:40 - Installing New Front Pads & Caliper Reassembly
9:39 - Rear Brake Pads Disassembly
11:10 - Installing New Rear Pads
13:22 - Ride Around The Block & First Impressions
15:13 - Conclusion
Steps:
Front
1. Unclip ABS sensor cable
2. Remove 13mm bolts
3. Remove caliper from disk
4. Take out R pin at bottom of caliper
5. Punch out guide pin with allen key
6. Slide out and remove brake pads
7. Clean caliper and disk with brake cleaner and rag
8. Insert new pads into caliper and install guide pin
9. Install R pin
10. Slide caliper onto disk
11. Apply Loctite onto bolts and install
12. Torque each both to 33ft-lbs (45NM)
13. Clip ABS sensor cable back
Rear
1. Remove R pin at top of the caliper
2. Punch out guide rod
3. Slide pads out of caliper
4. Remove metal brackets from OE pads
5. Install metal brackets on new pads
6. Clean disk with brake cleaner and rag
7. Slide new pads into caliper
8. Align pads and insert guide rod
9. Install R pin
Ride around the block and check if pads are seated property
---
Instagram: / thealexsun
Instagram: / 911mpg
My Riding Gear:
Arai Quantum X Diamond White: amzn.to/497xSCc
REV'IT! Airwave 3 Jacket (Discontinued)
REV'IT! Airwave 3 Pants (Discontinued)
Roland Sands Design Duck Canvas Jacket (Discontinued)
Five Stunt Evo Street Gloves (Discontinued)
My Camera Gear:
Panasonic GH5: amzn.to/3vMxquL
Panasonic Leica 8-18mm: amzn.to/3HuKAPk
GoPro Hero 8: amzn.to/47Ma3Pe
DJI Osmo Action: amzn.to/497f31P
Purple Panda Lav Mic: amzn.to/3tYkwJA
Disclaimer: As an Amazon Associate, I earn from qualifying purchases. Blah blah