Routing FCS 2 Fin boxes : Installation
Тәжірибелік нұсқаулар және стиль
In this video we break down what you will need when using the FCS 2 system, how to properly route your boxes along with best practices when routing. Hope you enjoy!
In part 2 we will be setting the boxes with epoxy.
All products available at: fiberglassflorida.com/fcs-fus...
Пікірлер: 13
Nicely done !
@FiberglassFlorida
5 жыл бұрын
bayshoregarage thank you!
Thanks Bagel ⚡️
Hey very nice informative video, as always!!! When you did your mark for the fin plugs did you do it in parallel with your stringer, and then the jig corrects it? If so, does it work the same way in fish-like surfboards?
Should the depth be flush or 1M below? Hearing conflicting info.
Thanks for explaining , but how did you get the marks ahead of starting? Is it hard to draw the marks and dots and stuff
What model makita router do you use?
Is it possible to change out the fcs1 plugs in my board to fcs2?
@FiberglassFlorida
4 жыл бұрын
in not 100% sure but it think it is possible. I would contact FCS in this case!
How much for fcs 2 router template?
Where do you buy this?
@FiberglassFlorida
3 жыл бұрын
fiberglassflorida.com/fiberglass-surf/fiberglass-surf-tools/fcs-fusion-ii-router-jig.html
Hey bagel.