Thank you! Our washer has been banging around and sliding across the floor since day one. I thought we bought a refurbished/broken washer from Lowe’s. After watching the video out of frustration I took it apart and there were no springs. I went to Lowe’s and bought 2.5 inch,5lb springs and it’s fixed. This washer was banging so bad with nothing more than a dish rag in the tub.

Great job!! This is the first video I found on putting rings in that is easy to follow ..

Great video quality and directions👍!!

I appreciate this video! My mom‘s washing machine has been doing this and I was thinking it was the suspension rods that are toast. But it doesn’t seem bouncy when you push it down but it shakes now I’m wondering if it’s those springs that you just showed took a crap. Ironically, out of every video, I’ve watched you were the only person that showed these. Not one other person has shown it they all say that it’s the rods. No one’s mentioned the springs at all!

@DELANDIGS

9 ай бұрын

update, the main shaft bearing could be bad and that isn't easily replaced

@MarioPerez-yi2tw

9 ай бұрын

@@DELANDIGS I am going to buy the springs. Thanks.

@hope6739

3 ай бұрын

Not all machines use springs

I just fid this to my washer last nite and the tub is still banging around very loudly. Is there anything else you can recommend yhat i do ??

@DELANDIGS

5 ай бұрын

If the load and balance springs have been changed, then the shaft bearing is bad. That is not an easy replaceable part. complete disassembly of the machine is required

@user-kf5zs1ec3q

4 ай бұрын

Same thing here replace rods and the springs added and still slap slap slap

@DELANDIGS

4 ай бұрын

@@user-kf5zs1ec3qHi, shaft bearing and or shaft is bad

About a month ago i replaced the suspension rods and also they came with those same springs i put them on and it still bangs is there any other reason for the banging that you may know? I have an amana washer and the banging is not as bad as it was but its still a problem any suggestions?

@DELANDIGS

5 ай бұрын

if the suspension rods, springs and balance springs have been replaced and you still hear a banging the transmission shaft is no good

@KLOVES2

5 ай бұрын

@@DELANDIGS ok thanks so much I will definitely check that out I'm just learning as I go I appreciate your response your a big help 😉

Hmmm….I just got a new whirlpool Machine (December 2023) and the tub does bump against the sides a few times when the spin cycle begins. When it speeds up it centers itself.

@DELANDIGS

5 ай бұрын

poor design eventually the shaft will go out

Where do i buy these springs???

@DELANDIGS

6 ай бұрын

Amazon

That’s A Whirlpool he said Whirlpool not Roper

@DELANDIGS

3 ай бұрын

Cause I just finished a Whirlpool, anyhow they are all about the same thx