Rollei Retro 80

Тәжірибелік нұсқаулар және стиль

A new chapter in film comparisons, I look at the differences between Kodak Tri-X as our standard and Rollei Retro 80. All films in these comparisons were shot using the same lighting and position, developed in Kodak D-76 using the manufacturer’s recommended time, and printed on Ilford Classic FB at 11x14 size using the same contrast settings. The printing time varied to cancel any changes in film base fog from film to film. I included the H&D curves for each film to see the individual differences and we look at the overall print, the spectral response of each film, and the grain characteristics.
Channel Merch, Discord, and more:
linktr.ee/The_Naked_Photographer
Join this channel to get access to perks:
/ @thenakedphotographer

Пікірлер: 20

  • @user-lh1fw6qh4d
    @user-lh1fw6qh4d7 ай бұрын

    As many other Rollei-badged films, this is Agfa Aviphot aerial film, also has infrared sensitivity.

  • @lensman5762
    @lensman57627 ай бұрын

    As has been mentioned, this is an aerial surveillance film. The infrared sensitivity is necessary to make sure that the film can cut through the atmospheric haze. I have messed with this film quite a lot and my best results were obtained using the Agfa Atomal ( Adox AT 49 ) developer, and the film rated at 40 ASA with reduced development.

  • @wv_
    @wv_7 ай бұрын

    It would be great to include an analysis of Orwo Wolfen NP100. I found the two rolls I shot quite unexpected. It is apparently Orwo UN54 with an additional anti halation layer

  • @LeDibeau
    @LeDibeau7 ай бұрын

    Nice comparison! My choice of film for architecture pix or long distance shots. Also for BLACK / WHITE portraits.

  • @herrgismo
    @herrgismo7 ай бұрын

    Thanks!

  • @mamiyapress
    @mamiyapress6 ай бұрын

    Tests have been carried out by other photographers and they have concluded that Rollei Retro 80s and Rollei RPX 25 are exactly the same film save for different development times.

  • @steven1000000000
    @steven10000000007 ай бұрын

    I've got a 30m tin of Rollei Retro 80S and have been very impressed with the sharpness and fine grain structure. I've developed in Ilford ID-11 (Kodak D76) and Iflord Microphen with good results. It might not be the best film for portraits of caucasions with the darkening of blue eyes, but very impressive in other areas. If you want high detail in architecture or landscapes, it might be worth a try. Whilst I have very high resolving films such as Adox CMS 20, this is a good balance between speed and resolving power/sharpness, to the point that I don't really use other slower films.

  • @T-Alb
    @T-Alb7 ай бұрын

    I like the Rollei Retro 80s. I always have a roll in my film loader. The carrier is also good for scanning.

  • @herrgismo
    @herrgismo7 ай бұрын

    "Roll I" Greez from Sax. 8-)

  • @FTropper
    @FTropper7 ай бұрын

    It's one of my favorite films. I like high contract B/W films in general, but this one is my favorite on the cheap side.

  • @andreaskarbe4030

    @andreaskarbe4030

    7 ай бұрын

    Same here. I've been waiting for this one since the series started. The first time I shot and enlarged this film, I couldn't believe that this amount of detail and sharpness was even possible for a more or less normal speed film. I mean you can really go huge in your prints with this film even with 35mm. And the best part, it is affordable.

  • @livonian
    @livonian7 ай бұрын

    Agfa Aviphot Pan 80 🙂 Datasheet says "Aviphot Pan 80 can be exposed as a 64 ASA to 100 ASA film" . Like this film a lot.

  • @Kref3
    @Kref36 ай бұрын

    I had quite some problems with the Retro 80s in the filmholder of my Hasselblad. Not on every picture, but on some and always on the side of the darkslide. I can only assume that when I change the film back and put the slide in and later out again, a tiny amount of light comes from the side, which is usually not a problem with other films, but due to the absolutely clear base it travels deeper into the film and creates light leak traces into the image area. I sometimes do see traces of light leaks with other films, too, but they are only on the edge of the film and do not reach the image part. My filmback had be refoamed quite recently, it is in good condition. So I wonder: Does anybody else know this problem with cameras like the Hasselblad, Bronica, Mamiya RB/RZ where you use dark slides to exchange film backs?

  • @yellowcrescent
    @yellowcrescent7 ай бұрын

    My first roll of Retro 80S in 120 had the mottling effects :( -- which seems somewhat common. I've heard 35mm is unaffected, so will have to give it a try. I think I remember seeing somewhere that RPX 25 is the exact same emulsion as Retro 80S, but haven't checked myself.

  • @cornwestern1689

    @cornwestern1689

    7 ай бұрын

    kzread.info/dash/bejne/opqV1M-ynJzWpNo.html

  • @cornwestern1689

    @cornwestern1689

    7 ай бұрын

    I thinks it's this guy's video, the side by side comparison speaks for itself.

  • @TrashTheLens

    @TrashTheLens

    7 ай бұрын

    I'm not sure if it is EXACTLY the same emulsion -- there were plenty of Aviphot speeds to choose from and rebrand. ;) But yeah, I've had the same mottling issues with RPX25 where I ended up with the texture of backing paper imprinted in the negatives. That's why it doesn't affect 35mm - no backing paper. I wish they made either RPX25 or Retro80s in 220 as this would be the best of both worlds. Even if the backing paper would imprint itself, it wouldn't affect the whole roll.

  • @Hector_Malot
    @Hector_Malot7 ай бұрын

    The grain is more apparent (and that's its charm) on the Tri-X which is normal and it is less contrasted, which is also normal for a 400 iso. However the Tri-X has more detail and a wider gray range, which is surprising. It's not a legend for nothing.

  • @yolklab
    @yolklab7 ай бұрын

    Thanks!

  • @TheNakedPhotographer

    @TheNakedPhotographer

    7 ай бұрын

    Thanks for your support!