A quick demo on using the Ridgid 378 and similar benders.The manual to this device is here (Ridgid website):cdn2.ridgid.co...
Very good video! Easy and clear explanation
Bc you put it on the r not on the 90 if you measure the marking on the bender that how much u were off
You’re hired.
Omg I've been putting the arrow on 0 and then lining my mark up with 90 or R
Write full name of bender and size of pipe, type too (hard or half-hard)
Did U use type B 3/4 copper?
Lol, I’m about an inch off
Eu tenho um tô vendendo
poor demo ... u wanted 12 inch and didnt even get it.
Пікірлер: 10
Very good video! Easy and clear explanation
Bc you put it on the r not on the 90 if you measure the marking on the bender that how much u were off
You’re hired.
Omg I've been putting the arrow on 0 and then lining my mark up with 90 or R
Write full name of bender and size of pipe, type too (hard or half-hard)
Did U use type B 3/4 copper?
Lol, I’m about an inch off
Eu tenho um tô vendendo
poor demo ... u wanted 12 inch and didnt even get it.