I've got 2 of these in a garden building, one for a kitchen sink and other in the bathroom basin. I've had them for about 1 year and not had any problems with them. I did notice they are fitted with 10amp fuses. If they do develop a fault, I'd just buy another one. they are not expensive to buy.
@reinis.berzins Жыл бұрын
I had installed 3 such electric taps/showers at home. But after 1-2 years they all started leaking water into the electronic compartment, creating a very slight short-circut. I won't trigger the home safety switch to turno off, nor create any sparks, but if you touch the the tap - you can feel a slight tingling. And also water drips out of this compartment on the floor. There is a small rubber button that connects the water pipe with the electronic compartment and is supposed to push an electric switch and seal the hole at the same time. But it looks like after 1-2 years this rubber becomes less elastic and doesn't do the sealing properly.
@EvansBoateng Жыл бұрын
Thanks
@abhishekabhishek3121 Жыл бұрын
Very nice
@Ritterkritterz Жыл бұрын
Thank you for sharing. It would be even better if you quickly showed your setup meaning the hit water tank and pump and power source. Can't understand if you said the name of the faucet.
@johnberto8861
Can I leave the mains water pressure connected all the time or should I add an inline tap ? Can it handle the mains pressure? Please
@KaptainKastle Жыл бұрын
I'm not sure I'd be comfortable with the electric cable almost in the Water 💦
@EricLDC
What do you do just plug it in a wall outlet?
@thandekantuli8080
how do one connect it
@justinjones8744 Жыл бұрын
cant believe your messing with the power connection so close to the water and i have one hard wired it didnt come with a plug as standard on a side not and reason i write this as just been to my shed to find my spout is hanging in the sink after i can only assume the internals somehow malfunctioned after installing around 4 months ago and never really used it but is now dead presumedly shorted out causing the element to heat up and melt the body making the spout droop forward 90 degrees the lever was still in the off position and allthoght the water is turned off at source no one has touched this atall and appears to have melted unless the frost has done this but garage is well insulated and not that cold inside so doubt that maybe just cheap chinease rubbish but beware ! make sure its hard wired and fused of course
Пікірлер: 32
Thanks for the video. Am certainly getting one
Thanks for your video
I've got 2 of these in a garden building, one for a kitchen sink and other in the bathroom basin. I've had them for about 1 year and not had any problems with them. I did notice they are fitted with 10amp fuses. If they do develop a fault, I'd just buy another one. they are not expensive to buy.
I had installed 3 such electric taps/showers at home. But after 1-2 years they all started leaking water into the electronic compartment, creating a very slight short-circut. I won't trigger the home safety switch to turno off, nor create any sparks, but if you touch the the tap - you can feel a slight tingling. And also water drips out of this compartment on the floor. There is a small rubber button that connects the water pipe with the electronic compartment and is supposed to push an electric switch and seal the hole at the same time. But it looks like after 1-2 years this rubber becomes less elastic and doesn't do the sealing properly.
Thanks
Very nice
Thank you for sharing. It would be even better if you quickly showed your setup meaning the hit water tank and pump and power source. Can't understand if you said the name of the faucet.
Can I leave the mains water pressure connected all the time or should I add an inline tap ? Can it handle the mains pressure? Please
I'm not sure I'd be comfortable with the electric cable almost in the Water 💦
What do you do just plug it in a wall outlet?
how do one connect it
cant believe your messing with the power connection so close to the water and i have one hard wired it didnt come with a plug as standard on a side not and reason i write this as just been to my shed to find my spout is hanging in the sink after i can only assume the internals somehow malfunctioned after installing around 4 months ago and never really used it but is now dead presumedly shorted out causing the element to heat up and melt the body making the spout droop forward 90 degrees the lever was still in the off position and allthoght the water is turned off at source no one has touched this atall and appears to have melted unless the frost has done this but garage is well insulated and not that cold inside so doubt that maybe just cheap chinease rubbish but beware ! make sure its hard wired and fused of course
Wastes so much water