Restoring a Bicron Surveyor M
Ғылым және технология
In this video, I try to restore a Bicron Surveyor M-X Scaler to its former glory.
One thing that I did not do was change the yellowed meter scale. Maybe I will do that in the future.
At 1:21 I meant to write "damaged", but the "s" was too close to the "d" on my keyboard.
Obligatory kudos:
The song is Gourmet Race by ColBreakz (Kirby Dubstep Remix)
• ColBreakz - Gourmet Ra...
Пікірлер: 6
What load did you use on your volt ohm to measure the highvoltage? I'm aware most manufacturers recommend a load of 1000Mohm, as not to harm the power supply. Is that the route you took?
@aelaboratories2572
3 жыл бұрын
I use a 90 MOhm voltage divider in series with a 10 MOhm multimeter. In my experience it is usually okay, but 1 GOhm would of course be better :)
hello, cool video! can you show where the wires go from the reset button? where do they connect to the board? thanks
@aelaboratories2572
2 жыл бұрын
Hello and thank you. Yes, I would be happy to show a few pictures of the inside of my unit. Use the link below. I hope this can help you. drive.google.com/drive/folders/1d4aDLRKtFI3MxqRYDnMuqGNYyLIxmPIk?usp=sharing
@raddigger
2 жыл бұрын
@@aelaboratories2572 thanks, your photos helped me a lot!
@aelaboratories2572
2 жыл бұрын
@@raddigger No problem, I am glad it helped!