Be sure to check out the How to Automotive Tool Store www.amazon.com/shop/howtoautomotive

@gasperajdnik5627

4 жыл бұрын

Tanks mate 👍. Well do.

@geeman215

4 жыл бұрын

Bob is the alternator on a 2010 terrain w/a 3.0 engine, the same position as this one? Same steps? Guy wants $200 to change my alternator. I think that's highway robbery.😦 My concern is the A. Having the right tools. B. The 1st nut you reconnected- w/the alternator not mounted. (Something) about a copper thread(?) & the electrical connections. I'm afraid of dropping or breaking something.

Single mom with kids, I’ve always worked in cars myself to save on $. Thanks so much for teaching alternator swap so simply and making it so people can understand!

I've even worked as mechanic for a couple years, and going back to not having a lift is quite a pain for me as I'm pretty big. Thank you for explaining this in a way that doesn't require me to lift the car 4 feet into the air!

One more time saving tip: skip the step of removing the 4 bolts and the air box lid. Loosen the hose clamp as you did then the two back bolts on the base of the air box. The whole box, top and bottom, will come out as a unit.

Huge Time Saver I could have figured out how to change it. I've change alternators before, but it's the little things like removing that stud and not fighting with the AC lines that make this such a great video, thank you very much... this is exactly why the internet is so powerful I would argue that I'm orders of magnitude more capable than any of my ancestor before me

Thanks very much for making this video. Great job. I watched this and knew I'd be able to swap out the failed alternator in my 2010 Equinox with 86k miles. Turns out mine was bolted on with 3 bolts, no stud like the one you found. I bought the car used from a lot so have no history on it but I would assume it's the original alternator. I also removed the entire air filter box in one piece rather than remove the top cover first like you did. Saved a bit of time. I also removed the air intake box, the large plastic box that attaches directly to the throttle body. Only have to loosen up the hose clamp attaching it to the throttle body so that's real easy to pull off. Gave me a bit more room to reach down there.

@HowtoAutomotive

4 жыл бұрын

Bob Winsor glad the video helped. Thank you for the tips I’ll give them a try on the next one. Thank you for watching!

@chrismanning9336

Жыл бұрын

Yeah the EQUINOX LOOKS EXACTLY THE SAME JUST GOT 3 BOLTS AND THE GROUND WIRE AND THE CONNECTOR TO THE ALTENATOR IS ALOT EASIER TO DISCONNECT BC THERE IS NO ALUMINUM LINE IN THE WAY BUT IT IS ALL THE SAME ALMOST THATS CRAZY LOL TOOK ME ABOUT 20 MIN ITS EASY FOR SURE

Definitely just helped me and my girlfriend out. Just finished up thanks brother

Thank you for this video it was "So Helpful "the step by step instructions was spot on and saved me a lot of money from repair shop labor fees.

@HowtoAutomotive

Жыл бұрын

Glad the video was helpful. Thank you for watching!

Awesome walkthrough going to tackle this tommorow on a customers car thanks !

best Video out there !!! Took me 45 mins would’ve taken 20 if I’d watch the video step by step !

Looking at all has been said! Thank you, looking forward to seeing more!

@HowtoAutomotive

3 жыл бұрын

Thank you!

Well explained and a great tip removing the stud .

@HowtoAutomotive

5 жыл бұрын

Thank you!

I used this and one other video to be able to replace the alternator on my 2012 equinox.....THANK YOU!

@mholloway4534

11 ай бұрын

NOT a mechanic, btw! lol Thank you!!!

Awesome video,thank you!

Thanks for the tip on the stud. I have to do this tomorrow

@thehawk5141

3 жыл бұрын

How did it go?

Nice job That was helpful. Thanks much

Perfect instruction thanks

Good tip on the stud removal for clearance. Wonder how seized that stud would be up here in the salty northeast after a few years 🤪 Happy Father’s Day Brian

@HowtoAutomotive

5 жыл бұрын

Thank you! The customer put an aftermarket stereo in it that killed the alternator. Happy Father’s Day to you!

Ty so much!!! Very helpful

great video thank you!

Thank you sir. Excellent tutorial

@HowtoAutomotive

7 ай бұрын

Thank you for watching!

You are the Man.... Thank you

Question: Do you have a video for installing an alternator in a 2008 Chevy Equinox LTZ? 😔

Do you need to take the engine mount off to replace a broken belt? I cant find a vid for a 2011 equinox. There's older vids where they had to

Great video bro tks

Great video

@HowtoAutomotive

5 жыл бұрын

Thank you!

Just purchased a new high output alternator, and have seen that it is recommended to replace the factory ground strap and charge wire, how would this be done?

what kind of 3/8 hand ratchet did you use?

thanks man you save me some money.

@HowtoAutomotive

2 жыл бұрын

Always happy to hear that! Thank you for watching!

Excellent vídéo💯

is the alternator on the 2011 terrain v6 in the same spot

I just paid $832 to replace the alternator on my 2012 V6. The dealership wanted $1200. Crazy

Mercier. Pour le vidéo

Thanks guys

@HowtoAutomotive

2 жыл бұрын

Thank you for watching!

Its the same process with a 2011 equinox v6???

Thanks!!!

@HowtoAutomotive

2 жыл бұрын

Thank you for watching!

THANK YOU!!

@HowtoAutomotive

Жыл бұрын

Thank you for watching!

HI, I have a 2016 chev equinox (2.4L) and I checked the voltage while car was running (under load with lights, radio, heat on) and it's sitting at 15.2, is this too high? If so, I might need to replace my alternator?

@bartrowe3705

2 жыл бұрын

I have 14.90 on my original as was looking to change out thinking regulator was bad as the battery got so hot it boiled the water out. I saw the same 14.95 on video, IS THIS NORMAL for this model? A year later what have you done or what issues have surfaced?

@doubleitp

2 жыл бұрын

@@bartrowe3705 No it's not normal I found out, my alternator was over charging the battery. The second I replaced the alternator everything went back to normal.

Can you make a video vhit a tour araund your machanik garage?

What size socket for the bolts

Has anyone installed a High Output Alt in their terrain? I'm looking for advice

Two Thumbs Up.

@HowtoAutomotive

5 жыл бұрын

Thank you!

Any tips on how to get the belt back on to the alternator pulley?

a Delphi goes down ….. well at least no coolant fan removal im getting the long reach and the no fog glasses thanks brian

@HowtoAutomotive

5 жыл бұрын

I can’t wait for those to come out. I’m looking forward to making more videos with them. Thank you for watching!

So, mine just went out. If I take it to a shop, labor shouldn't be anymore than 3 hours right? I just want to make sure they don't try and rip me off. I'm saying 3 hours because they "jave" to do their diagnostic, the actual swap, take another hour to make the job worth their while, then do proper testing ti make sure everything works properly. I just got a new battery probably about a year ago, I know it's dead now, but under warranty. So I'll need to go and get a new battery once the new alternator is in. So estimated cost for this repair should be a little over $2k? That being parts, diagnostics and labor correct?

Great video. I am surprised the alternator needs to be replaced. What year is it

@HowtoAutomotive

5 жыл бұрын

This was a 2016 the customer tried to put one of the aftermarket stereo systems in there and overpowered it.

So when I took my alternator out, the main power feed wire came out with it. Connected to the alternator. So I swapped the wires over, but I don’t know where the other end of the power feed wire goes 😭

@HowtoAutomotive

11 ай бұрын

So, usually they run to the fuse box under the hood.

Hi Brian, I watched your video on How to Replace an Alternator on a 2010 - 2017 Chevrolet Equinox. One question, the voltmeter in the video showed an output of 14.95 volts. From what I have seen online, the output should not exceed 14 volts. Is the voltage output on this new alternator okay, or too high? My current 2010 Equinox has an output of 14.67 and my voltmeter indicates it is too high so I am wondering if it should be replaced. Thank you for your assistance.

@bartrowe3705

2 жыл бұрын

I have 14.90 on my original as was looking to change out thinking regulator was bad as the battery got so hot it boiled the water out. I saw the same 14.95 on video, IS THIS NORMAL for this model? A year later what have you done or what issues have surfaced?

If you disconnect the battery, does the ecm still need power to stay alive

How many times do you tighten the bolt on the belt wheel?

@laramie371

Жыл бұрын

Just once bro

An ECU right in top of the battery! I saw a film by Scanner Danner of him tracing a wiring short on a Chevrolet Equinox. He found some corroded wires on the harness coming from the ECU that was mounted on top of the battery. I reckon that's a common thing for y'all full-time mechanic folk. Engineers, whether automotive or not, should be forced to work on everything they design. Three questions my friend, did you try the normal serpentine belt removal tool to access the tensioner first before using your bent-handled ratchet? The ratchet seemed to provide easier access than the straight, belt removal tool would. Also, you took off the serpentine belt just enough from the alternator pulley, you didn't have any issues of resetting the belt on any of the other pulleys? One last question. How was that engine bay so clean?

@HowtoAutomotive

5 жыл бұрын

Donald Hollums I can see in the future that PCM being mounted on the battery is going to have some issues with corrosion. As far as the belt tensioner goes there was plenty of room to get just about any style ratchet or belt tensioner tool in there. It was just a matter of choice. I chose the ratchet because not everybody has a belt tensioner tool. The engine bay was clean because it’s a California car with only 30,000 miles on it.

This is same process to do that on Cadillac SRX 2016 3.6

I can’t get the stud out, it’s too tight and starting to strip. What should I do?

@HowtoAutomotive

3 жыл бұрын

If you can’t get The stone removed then you’ll have to create clearance by removing the AC line. Which means evading the system then unbolt the hose to make room.

We’re struggling to get the belt off. Any tips or ideas

@AFatherToTheFatherless

Жыл бұрын

Update

Wat all tools do I need

2013 GMC terrain sel 3.6

Here in the Rust Belt, the 5mm hex on that stud is useless. Double nut it to get it out. 😎

Looks pretty new. Why did you replace it?

@HowtoAutomotive

5 жыл бұрын

They tried to hook up one of those big stereos systems and killed it.

@fortyforfree

10 ай бұрын

@@HowtoAutomotivewhat were you trying to put? I was worried about frying my 2012 terrain, so I put a weak single 12 inch sub. I hate it lol. Looking to put some decent 2 12’s. Maybe 500-750 rms

What about a 2014 chevy captiva

I never seen a ECU right on top of the battery

@HowtoAutomotive

5 жыл бұрын

I can think of better places to put it. Thank you for watching!

@geeman215

4 жыл бұрын

I had hell tryna get it loose to take the battery to be charged... I remember the good old days when just had to disconnect Pos & Neg cables & be on your way😏

My car Wong after using starter fluid

I replaced my alternator, but my serpentine belt came off.

This doesn't work for 2010 V6.

2011 terrian is different 4 cycl

Who are the 15 people that hit, thumbs down 🤔🤣

@HowtoAutomotive

3 жыл бұрын

sicric79 People are always going to hate.

@danielbosien4826

3 жыл бұрын

The ones that paid almost $1k to the dealership for something they could've done themselves. I'm not mechanically inclined but after watching the video I'm comfortable tackling the job myself whenever I need to.

2011 is n

This is the worst video I’ve ever seen. He went from the alternator being in to it being out and didn’t show how to take it out.

@robkesik6382

11 күн бұрын

How much hand holding do you need? He showed you how to remove all the bolts and connectors. Pivot it up and out.

@darthjar9117

11 күн бұрын

@@robkesik6382 that’s the whole point of an instructional video. He might as well have just said take out the old alternator and put the new one in. Why even bother showing anything?

@robkesik6382

10 күн бұрын

@@darthjar9117 ok.. I'll complete the instructions. Once you do everything he suggested., put your left hand on the left side of the alternator, and your right hand on right side. Now contract your bicept muscles to perform a lifting action, (as if you were lifting, you know, ANYTHING else).

@robkesik6382

10 күн бұрын

@@darthjar9117 he told you, to remove the air box, what bolt sizes to use , how to remove the accessory belt, what size and location of the nuts and bolts for the alternator, a suggestion to remove the stud for easier access (and the size of the socket needed), how to remove the connectors, what size socket is needed for that. He literally told you everything, for free, and you have to sit here and bitch about him. Does your mom wipe your ass for you too?

@darthjar9117

10 күн бұрын

@@robkesik6382 ummm which side do I pull out first?

🙏many blessings it was helpful n easy to do, my family thanks you, money saver🦾

Great video

@HowtoAutomotive

2 жыл бұрын

Thank you!