You are so practical. Great stuff.

I been looking for this solution for years! Thank you for showing us how to do it, I kept getting by witj duct tape wrapped around the bolt, it would stop the rattle for a month or 2 then it woulf rattle again,I will take the bolt ant bring it to the dealer to make sure I get the right one.

I enjoy your content I greatly enjoy watching your show!

@57bagre

3 жыл бұрын

Thanks Landon.

@landonbrown6568

3 жыл бұрын

Gordon Robertson DIY would you do a video about how to spec out a truck for over the road! best motor,transmission,and rear gears how to make money trucking I’m interested in this 😁⭐️⭐️⭐️⭐️⭐️I’d like to here your ideas on this ! I’ve followed your channel for a long time 👍🏻👍🏻

@57bagre

3 жыл бұрын

No I can't do that. I don't do any research on that, I just maintain what I have and share how I do it. Thanks for following my channel Landon.

Great job GORDON👍👍👍

Good video again and glad to see you making video again keep working hard my friend be safe on the road

@57bagre

3 жыл бұрын

Thanks Glenn.

I have to change mines out... good vid.

Just bought the door panel and parts ... Good video Sir

@57bagre

3 жыл бұрын

Thanks.

I would certainly use some in this case!

Gordon. Good video. Stay Safe

@57bagre

3 жыл бұрын

Thanks Don.

any video on replacing hinges and rubber around door ?

Have you ever changed motor mounts on Columbia or similar? Is it hard, do you have to change comlete part or just the ruber piece?

@57bagre

3 жыл бұрын

No but I wanted to on mine when I did the clutch last time but the bolts were seized and the area was too tight to torch them out safely without calling my job and asking for an undetermined amount of time off not knowing what kind of can of worms I was going to open up. The front motor mount doesn't look too scary though.

thank

Gordon , No Anti-Seize on threads?✌

@57bagre

3 жыл бұрын

Nope, and it cracked loose as soon as I put the wrench on it, it's only been on there 23 years. Thanks for watching Edward.

Usually the passenger side last's forever unless it's a team truck!

@57bagre

3 жыл бұрын

23 years hammering on rough roads does a number on everything.

I think Freightliners are designed to fall apart. I had one that the rivets on the hood loosened up and they would spin while driving down the road.