mant thanks for detailed video!

Tolles Video, mein Auto läuft wieder! Daumen hoch.

@schluesseldienst_muzler_de4067

3 жыл бұрын

Danke

Very well explained and an excellent job, as always! Congratulations, you are a truly professional! Old Renaults can be very tricky, I had experience😀😀😀.

@schluesseldienst_muzler_de4067

Жыл бұрын

Thank you Andreia. New Renaults can be horrible too. I heard much about killing the "UCH". So far I've been lucky with that.

@Renegada-ei1ll

4 ай бұрын

Uch 2016 keyless go clio iv Megane warning

Renault immos spinnen oft, immo off ist hier oft die beste Lösung. Video ist super

@schluesseldienst_muzler_de4067

3 жыл бұрын

Danke.

Hi, I would like to ask you for some informations, I have the same car and one key which can just turn on the engine but can't remotely unlock doors because it's half damaged, and holding the button to lock the doors near the gear shift and then clicking the button on the key doesn't work since the key can't transmit or receive rf. I have nowhere to get another key since all you find online is for phase 2 and this is phase 1. Any idea how to get a remote to unlock the car? I also thought about a programmable 433mhz remote used to open garages, but I don't have a key to sniff the signal from.

Hello Need some informations I try to do one clio 1 same on thé vidéo I didn't reach to desolder thé eeprom it was hard for me Tried with hot air How did you Do it please

@schluesseldienst_muzler_de4067

Жыл бұрын

Hi. The eprom is glued to the board. You can read it in circuit ( on the board ). Or you can remove it with a small screwdriver when you heat it up with hot air. Be sure that all legs are heated up enough. Hope it helps.

@myroad5469

Жыл бұрын

@@schluesseldienst_muzler_de4067 thank you very much for your reply