So dissipated hot air caused by plastic housing! Then I repaired 3-pin soldering and it was good!

First warm hot air, then replenish 3 connectors on the panel and finally back to gluing!

Hi, I did this for the first time, I was warming the adhesive between the two plastic elements with a hot air blower, and I was holding a very strong adhesive.I took the bottom part in the tub and then I spun a star key to the right to the left I was just pushing it down! I'm not sure what to do with it, but I'm not sure what to do with it. will!I used the Google translation program, sorry if it is not interpretable!

Soldering of the panel cracking spike is loosened in general.With to see the magnifying glass, you can not always see it with a naked eye!

Go prelemiv kontaktite i raboti perfekno Dacia logan 2008 g

Alene, da li mozda znas koliko impulsa taj senzor daje za jedan okretaj tocka? Vidim da ima 16 ili 20 polova na samom rotoru enkodera ali ne znam dalji odnos.

Sir pls help .How meaning A,B1,B2 pin in sensors

Any English transcript? that would be great

Poz druze gde se ona nalazi senzor brzine clio 2 imam problema snjim al neznam gde je

Where is this sensor located?

@alenzigri2777

5 жыл бұрын

thanks for your comment. This speedo-sensor is plugged in into the gearbox. It is quite easy to locate it. You just have to twist it into the proper direction and gently plug it out from the gearbox, but you have to disconnect the cable firstly, ofcourse

@user-bw4rr4kd9n

5 жыл бұрын

Alen Zigri Thank you for the fast answer....keep is going :)

@alenzigri2777

5 жыл бұрын

at the beginning, try to spry it with WD-40 or similar spray

@aubreynoraqa3919

4 жыл бұрын

Where exactly on the gearbox? Do you access it underneath the car or from top. I have scenic grande 2. No speed reading

I cannot remove it, i twist it both sides but wont come of and about the wires how i can unattach them ?? Please ??

@alenzigri2777

5 жыл бұрын

I've been facing the same issue when I tried to remove it. Firstly disconnect the cable, than grab it with your left hand probably (since approaching from the driver's side that woulld be more convenient) and gently but with a proper dosage of force try to twist it (I'm not sure anymore whether it is a clockwise rotation or not)

@Muhammedsuleyman97

5 жыл бұрын

@@alenzigri2777 i did that on both sides to rotate it and pulled as hard as i could but no success and i haven't got a clue how to dissconect the cables can you show me with video or add me on fb or skype i really need your help pls.

@alenzigri2777

5 жыл бұрын

unfortunataly I do not have any additional video available. Concerning the cable, it is quite sipmple, since there is the simpe 3-pin connector and you should just pull it out from the socket (it is the same as all other sensors in this car). Anyway, you've probably noticed in this video as well as you shouldhave in all other videos you could find on KZread, there were two ''pins'' beneath the blue rubber seal ...by which this sensor is sticked into the gerabox. Try to press them, trying that way to release it ... Maybe that would be helpfull

@Muhammedsuleyman97

5 жыл бұрын

@@alenzigri2777 haha sega prvpat go gledam videovo so glas i pretpostavuvam deka si srbin ili hrvat jas sum od makedonija. Probav na sekakov nacin nejkese da iskoci, ali ke probam kako sto rece da gi pritisnam tie dva zupcanika. Da go izvadam.

@alenzigri2777

5 жыл бұрын

da, hrvat sam :) Probaj i pritisni ta dva pina/zupca pa ga pokusaj izvaditi