So thankful! Been trying to fix my faucet but don't know how to remove the drawers thanks to this video it save me a couple of hundreds 👍🙏 on calling a plumber for a simple job😊😊😊

Thank you for the video, my tinkering messed up my drawer and I was able to fix it after watching this.

Short video, no stupid annoying narration, so nice.

Thank you very much. I kept thinking about how to get the box out. So simple

Thank you very much I stopped pulling my hair out after watching this video thanks again

You are great man, i resolved my problem ❤

Огромное спасибо!❤ Как просто всё решается) Надеюсь, у меня тоже всё получится.

My drawer front fell off and I can’t get back on can you help me

Those are some cool socks

Immediately see an error in the method used in removing the drawer. You should not lift the drawer using the two tubes, you should lift from the side of the drawer. When disconnecting the drawer from the runners, just make sure your fingers are not under the drawer as when you lift the drawer the runner will come out the bottom

@MikkoAuvinen

5 ай бұрын

The side bars are very robust in this drawer model and I as you said it's also safer for fingers.

@otishendryx

2 ай бұрын

We have a similar draw however those tubes can pop out easily to the left (as they’re only snap locked into the front panel). It’s safest to lift with your palms beneath the draw, just to be safe.. but it’s a good video nonetheless.

@jexxux1

10 күн бұрын

Can this type of sliders accept push to open pins?

So, what does the locking pin look like and where might it be?

@MikkoAuvinen

Ай бұрын

There are various mechanisms and locking possibilities, pins, screws, etc. E.g. www.wikihow.com/Remove-Drawers For locking pin example, see the very last picture in this Ikea drawer guide: www.ikea.com/fi/en/assembly_instructions/aengsjoen-wash-stand-with-drawer-oak-effect__AA-2381349-2-100.pdf

Ours is a Roca fitted 11 years ago, the runners are concealed, the draw doesn't lift so no help.

those slides have the tendency to fall apart. how to fix them? the video is not much of a use

Gracias, si no es por ti todavía estoy intentando sacarlo.

@MikkoAuvinen

8 ай бұрын

Muchas gracias y me alegra saber que mi vídeo fue útil.

Thanks - I was able to remove the drawer but for some reason the drawer will not go back in. The drawer sits on the runners but seems to be unlatched to the metal runner and I keep banging this into place but it is no longer connected. Any tips?

@mxsniper223

Жыл бұрын

did you found any solution?

@MikkoAuvinen

Жыл бұрын

The problem might be that soft-close spring mechanism at the back end of the slide has slipped to back position. You just need to pull it back to front position and then try to attach the drawer to slides. See this video for one example: kzread.info/dash/bejne/hoSNu8WPkbTWqM4.html

Good Job Pacman ;)

Thanks! Very useful

Dude, thank you!

What's the brand name of your kitchen, please? I have the same rail mechanism but I can't get it out like you do

@MikkoAuvinen

Жыл бұрын

We bought kitchen cabinets from a small dealer. No brand name visible but most companies use similar mechanisms.

@galahaaad

Жыл бұрын

@@MikkoAuvinen Thank you, you were right with locking pin. I spent several hours figuring out how to release them, finally I've found a way with flat screwdriver. It needed just a little tweak between pin and front part and it came off the rail easily

Nie um die Stangen greifen bei Schubladenrausziehung!!! Sondern ganz aufmachen Zwei Hände unten das front und nach hoch greifen.

I have same drawer. Now it's stuck. It has chopping board. So I don't know how can I open it. It is top drawer. Can you please help me?

@MikkoAuvinen

Жыл бұрын

Try to trick to open a drawer when something inside is wedged and prevents opening it: kzread.info/dash/bejne/nZ2H2qV_cbyTgZc.html

Thank u so much

Большое спасибо!

👍

Pulling the drawer to remove it using your method is wrong. It weakens the mechanism. You will find to the left and right of the drawer and attached to the actual drawer runner (not the cabinet slide(s), a lever just below where the drawer adjustment is. Feel for these and press upwards to release the drawer.

@MikkoAuvinen

6 ай бұрын

Thanks for info. For me this method feels a bit violent, too. But unfortunately there's no such levers in our drawers. Pulling up seems to be the only way to remove them. Also this official looking video seems to give similar instructions for some other model so I guess that's somehow correct method for this kind of drawer mechanism: kzread.info/dash/bejne/eWaIypR7YLDMoZM.html

@PetiteBluebirdgirl

6 ай бұрын

@@MikkoAuvinen having looked, my method is for ikea Maximera. I note that you have the Exceptionell. How to remove. On both sides left and right and underneath, you will find a cog mechanism. Turn towards yourself (located about 1½"/3.5cm from drawer front and the drawer should come out. It actually provides the instructions in the essembly leaflet which you would have received when you purchased it. Pulling any type of soft close/open drawer will eventually damage it.

@PetiteBluebirdgirl

6 ай бұрын

@@MikkoAuvinen that link is not an ikea drawer, so the system to remove it isn't the same.

@PetiteBluebirdgirl

6 ай бұрын

@@MikkoAuvinen this link is for your drawer kzread.info/dash/bejne/eHlqmLWEn7a3pps.htmlsi=bGKIw70PMgO8J0Dc

@MikkoAuvinen

6 ай бұрын

@PetiteBluebirdgirl Ours is not Ikea, it's from a smaller vendor and has different mechanism. Tried to see if it has similar press and pull option but there's none. I see that the only way to remove this drawer is to pull it upwards.